LINK-BELT MFXS232N flange bearing 2 holes

LINK-BELT MFXS232N is a reference of flange bearing 2 holes, within Bearing housings. Request a quote for MFXS232N via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The 200 series 2-bolt flange mounted bearing is a ready-to-mount unit that combines an insert bearing with a flange housing. It is fastened with two bolts and is used to support rotating shafts in equipment where a compact front mounting is required. MR Accesorios Industriales sells this LINK-BELT line in Buenos Aires, Argentina.

The MFXS designation followed by a three-digit number and the letter N identifies these flange mounted bearings. The middle number, as in MFXS216N or MFXS232N, indicates the insert size within the 200 series: the higher the number, the larger the shaft diameter. The final N corresponds to the standard mounting configuration of this family. Each part number summarizes the housing type, the series and the shaft size in a single reference.

These mounted bearings are used in conveyors, elevators, mixers, blowers and process lines in food, chemical and materials plants. In Argentina they appear in milling, packaging and grain handling equipment, where the two-bolt front mounting simplifies fastening to sheet metal or structure. Their flange housing allows the shaft to be aligned and absorbs combined loads in tight spaces.

To select the correct part number, start from the shaft diameter you need and the type of load: radial, axial or combined. Check the distance between the holes and their diameter so they match the existing structure. The insert usually comes lubricated and with seals that retain grease and block dust; if the environment is humid or has particles, it is advisable to check the sealing type. Mounting requires flat, clean supports, even tightening of the bolts and alignment control to avoid stress on the bearing.

LINK-BELT is a benchmark brand in mounted bearings, and its designations cross-reference with those of other brands that use the same series and shaft size logic. When requesting a quote, the most practical approach is to provide the complete part number, for example MFXS219N, and the main dimensions of the equipment. MR Accesorios Industriales will indicate the compatible alternative within the brands it sells and advise you if you need to replace an existing mounting.

If you have doubts about which part number fits your equipment, send the model of the old bearing, a photo of the housing or the shaft and hole dimensions via WhatsApp. At MR Accesorios Industriales we will quote the corresponding LINK-BELT reference and support you in the selection. We can also evaluate in-house manufacturing of special housings if the standard mounting does not fit your machine.