LINK-BELT FC3CL2M100N flange bearing 3 holes

LINK-BELT FC3CL2M100N is a reference of flange bearing 3 holes, within Bearing housings. Request a quote for FC3CL2M100N via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

LINK-BELT FC3CL2M series flange bearings are 3-bolt flange mounted bearing units designed to secure rotating shafts to flat structures. They are used when the shaft must sit perpendicular to the mounting surface, with rigid, compact support. MR Accesorios Industriales sells this line for industrial applications in Buenos Aires, Argentina, and advises you on choosing the right variant for your equipment.

The designation of this series reads in blocks: FC indicates the flange type, 3 the number of holes, CL the locking system, M the housing material and the final N the sealing type. Examples such as FC3CL2M25N or FC3CL2M40N show how the middle number changes with shaft diameter, which can vary by part number. That figure is the first thing to check to know whether the unit fits your shaft.

These units are found in belt conveyors, bucket elevators, mixers, mills and process equipment. In food, cement, mining and aggregate processing plants in Argentina, the 3-bolt flange allows mounting onto sheet metal or structures without machining, which is key when access is difficult. They are also used in fans and centrifugal pumps where firm support and simple alignment are required.

To select correctly, check the shaft diameter, the load type (radial, axial or combined) and the environmental conditions. The N sealing of this series protects against dust and moderate moisture; if there are frequent washdowns or fine particles, additional protection should be considered. During mounting, rest the flange on a clean, flat surface, tighten the three bolts gradually and in a cross pattern, and check that the shaft turns freely before start-up. Correct lubrication and careful alignment extend bearing life.

When replacing, always compare the full designation and the main dimensions: shaft diameter, hole spacing and flange outer diameter. Equivalent series from other brands may differ in sealing or locking system, so do not rely on the shaft number alone. If you have the original part number, send it as is; if not, send a photo and the flange measurements and we will tell you the compatible alternative.

If you need this LINK-BELT flange bearing unit, write to us on WhatsApp with the part number that matches your equipment. At MR Accesorios Industriales we will quote you promptly and help you confirm that the variant is the right one for your application.