LINK-BELT FC3CL243N flange bearing 3 holes

LINK-BELT FC3CL243N is a reference of flange bearing 3 holes, within Bearing housings. Request a quote for FC3CL243N via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The LINK-BELT FC CL N flange bearing is a 3-bolt flange mounted bearing, series 200, per the Rexnord / Link-Belt Bearings BR101 catalog. It is used to support rotating shafts on flat structures, fastened with three bolts and aligned directly to the flange hole. It is a robust solution for equipment that needs compact support, easy mounting and dismounting, and the ability to handle combined loads. MR Accesorios Industriales sells this line.

The FC CL N designation is read in parts: FC indicates the 3-bolt flange housing; CL corresponds to the mounted bearing series with set screw locking; N indicates the cast iron housing with grease fitting lubrication. The intermediate numbers refer to the shaft diameter in inches per series 200. Thus, the complete code identifies size and configuration without ambiguity.

In Argentine industry, these housings appear in belt conveyors, bucket elevators, mixers, mills, centrifugal pumps and process equipment in food, chemical and cement plants. They are also found in agricultural machinery and packaging lines, where the 3-bolt flange simplifies mounting on sheet metal or profiles. Their design allows shaft alignment with moderate tolerances and absorbs small misalignments typical of welded structures.

To select the housing, check the shaft diameter, the load type (radial, axial or combined) and the environmental conditions. The standard sealing protects against dust and moisture; if there are frequent washdowns, additional seals should be evaluated. Mounting requires a flat surface, bolts tightened in a cross pattern and shaft alignment before fastening. Lubrication is done with lithium grease or equivalent, without overfilling the housing. Excessive axial play may indicate insert wear.

LINK-BELT housings of this series are interchangeable with other brands that use the same 3-bolt flange standard and series 200 shaft diameters. When requesting a quote, it is advisable to compare flange dimensions, hole spacing and bolt diameter, as well as the insert locking type. MR Accesorios Industriales can indicate the compatible alternative. Always prioritize dimensional verification before replacing one housing with another.

If you need a LINK-BELT FC CL N flange bearing, write to us on WhatsApp with the complete code or the shaft dimensions. At MR Accesorios Industriales we will quote you promptly and advise you so that the mounting is correct. We can also offer you variants of the same family if your application requires another type of fastening or sealing. Send your inquiry and we will reply with the best solution for your equipment.