Flange bearing 3 holes LINK-BELT FC3CL222N

LINK-BELT FC3CL222N is a flange bearing 3 holes reference, within Bearing housings. Request a quote for FC3CL222N via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The LINK-BELT FC CL N flange housing is a 3-bolt flange mounted bearing, series 200, according to the Rexnord / Link-Belt Bearings BR101 catalogue. It is used to support rotating shafts on flat structures, with mounting by three bolts and direct alignment to the flange hole. It is a robust solution for equipment that requires a compact support, easy to mount and dismount, and able to withstand combined loads. MR Accesorios Industriales supplies this line as an official brand.

The FC CL N designation is read in parts: FC indicates the 3-bolt flange housing; CL corresponds to the mounted bearing series with set screw locking; N indicates the cast iron housing with grease fitting lubrication. The intermediate numbers, as in FC3CL214N or FC3CL216N, refer to the shaft diameter in inches according to series 200. Thus, the complete code allows the size and configuration to be identified without ambiguity.

In Argentine industry, these housings appear in belt conveyors, bucket elevators, mixers, mills, centrifugal pumps and process equipment in food, chemical and cement plants. They are also found in agricultural machinery and packaging lines, where the 3-bolt flange simplifies mounting on sheet metal or profiles. Their design allows the shaft to be aligned with moderate tolerances and absorbs small misalignments typical of welded structures.

To select the housing, check the shaft diameter, the load type (radial, axial or combined) and the environmental conditions. The standard sealing protects against dust and moisture; if there are frequent washdowns, additional seals should be evaluated. Mounting requires a flat surface, bolts tightened in a cross pattern and shaft alignment before securing. Lubrication is done with lithium grease or equivalent, without overfilling the housing. Excessive axial clearance may indicate insert wear.

LINK-BELT housings of this series are interchangeable with other brands that use the same 3-bolt flange standard and series 200 shaft diameters. When requesting a quote, it is advisable to compare flange dimensions, hole spacing and bolt diameter, in addition to the insert locking type. MR Accesorios Industriales can indicate the compatible alternative if the original code is not available. Always prioritize dimensional verification before replacing one housing with another.

If you need a LINK-BELT FC CL N flange housing, write to us on WhatsApp with the complete code or the shaft dimensions. At MR Accesorios Industriales we will quote you shortly and advise you so that the mounting is correct. We can also offer you variants of the same family if your application requires another type of locking or sealing. Send your inquiry and we will respond with the best solution for your equipment.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.