Flange bearing 3 holes LINK-BELT F3Y223N

LINK-BELT F3Y223N is a flange bearing 3 holes reference, within Bearing housings. Request a quote for F3Y223N via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The Link-Belt 200 series 3-bolt flange bearing is a mounted bearing ready to bolt onto sheet metal, iron or structures with three anchoring points. It is used when the shaft line needs firm and compact support, with the flange as the mounting surface. MR Accesorios Industriales supplies this Link-Belt line in Buenos Aires, Argentina, and quotes the exact part number you need on WhatsApp.

The designation of these bearings reads in blocks. The initial F indicates the 3-bolt flange; the first number after the F is the shaft diameter in inches; the Y indicates the mounted bearing series; the following two digits correspond to the 200 series; and the final N identifies the locking type. Thus, F3Y212N is a flange bearing for a 2-inch shaft, and F3Y222N covers the upper end of the series. The complete part number defines it unambiguously.

These bearings appear in belt conveyors, bucket elevators, mixers, screens and process lines in food, cement, aggregate and water treatment plants. In Argentina they are found in equipment where the shaft must be supported on a flat face and mounting access is limited. The three-bolt flange allows alignment and fastening with few points, which is useful in folded sheet metal frames and profile structures.

To select correctly, start from the shaft diameter and the load type: predominantly radial in conveyors, with a moderate axial component in screws and agitators. Verify the sealing according to the environment: dust, water or frequent washing require tighter seals. During mounting, rest the flange on a flat, clean surface, tighten the three bolts in a cross pattern and check that the shaft turns without hard spots. Lubrication is replenished according to the duty cycle and grease type.

Interchangeability between brands is resolved by shaft number, series and flange type, not by the commercial part number. A 200 series 3-bolt flange bearing from another company can replace a Link-Belt if the shaft diameter, hole spacing, center height and locking type match. Send the dimensions or the drawing and we will indicate the compatible alternative. Do not mix series or adapt the flange with shims: that misaligns the bearing.

If you have the equipment part number or the shaft measurement, send it by WhatsApp to MR Accesorios Industriales and we will quote the corresponding Link-Belt bearing. We also advise you on sealing, lubrication and mounting so that the support runs aligned and lasts as long as it should.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.