LINK-BELT F3CL2M30N flange bearing 4 holes

LINK-BELT F3CL2M30N is a reference of flange bearing 4 holes, within Bearing housings. Request a quote for F3CL2M30N via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The 4-bolt flange bearing of the Link-Belt CL series is a mounted bearing that combines the cast iron housing with the insert bearing, ready to be fastened to a flat surface with four bolts. It is used to support shafts in equipment where the flange solves the anchoring and allows the assembly to be aligned. MR Accesorios Industriales sells this line in Buenos Aires, Argentina, with technical advice to choose the correct size.

The CL series designation reads in blocks: the letter F indicates the flange housing type, the number that follows the F corresponds to the pillow block size, CL identifies the series, and the letters after the number indicate housing variants, such as the hole position or the sealing type. Examples in the line range from F3CL2M20N to F3CL2M50N, with suffixes that distinguish versions within the same size. Send the complete code on WhatsApp and we'll tell you the corresponding variant.

In Argentine industry, these pillow blocks appear in belt conveyors, bucket elevators, mixers, mills and process equipment where the shaft is supported on a sheet metal or cast iron structure. They are also seen in food, cement, grain and bottling plants, because the four-bolt flange simplifies mounting on existing frames and allows the assembly to be removed without completely disassembling the shaft.

To select the pillow block correctly, take into account the shaft diameter, the load type and the direction of the forces. The four-bolt flange works well with radial loads and some axial thrust, but it is advisable to verify the alignment of the mounting surface before tightening the bolts. Check the sealing according to the environment: dust, water or frequent washdowns require tighter seals. Lubrication of the insert and internal clearance also influence the service life of the assembly.

Flange mounted bearings are interchanged between brands by shaft size and housing configuration, not by the manufacturer's complete code. If the equipment has a Link-Belt CL series pillow block, we can offer you the same size from another line that better suits the mounting. Send us the code on the part, the shaft size and a photo of the support, and we'll quote the option that solves the replacement.

MR Accesorios Industriales sells the Link-Belt line in Buenos Aires, Argentina. If you need a CL series flange bearing or a variant you don't see, message us on WhatsApp with the code or model: we'll quote it and tell you the compatible alternative promptly.