LINK-BELT EPB224M85FH flange bearing 4 holes

LINK-BELT EPB224M85FH is a reference of flange bearing 4 holes, within Bearing housings. Request a quote for EPB224M85FH via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

Link-Belt B22400 series 4-bolt flange bearing housings are mounted units that combine an insert bearing with a square cast iron flange housing, designed to secure the shaft to a flat surface using four bolts. They are used when radial loads and some axial thrust need to be supported in power transmission equipment, and their design allows the assembly to be aligned and mounted on plates, frames or machine structures. MR Accesorios Industriales sells them in Buenos Aires, Argentina.

The designation of these housings is read in blocks: the B22400 series identifies the housing and insert bearing family, and each item code adds the shaft diameter and the mounting type. The number after the M indicates the shaft size in millimeters, and the FH suffix corresponds to the 4-bolt flange variant. Thus, references such as EPB224M60FH or EPB224M100FH share the housing and change the shaft diameter. To choose, send the full code and the shaft size.

These housings appear in conveyors, belts, elevators, mixers, blowers and process lines where the shaft must be supported on a flange rather than on a foot. In food, cement, aggregates and water treatment plants they are found in equipment with long shafts that need several support points. In Argentina they are seen in grain plants, meatpacking plants, tanneries and plastics factories, always mounted on metal structures or masonry with the four flange bolts.

To select correctly, take into account the shaft diameter, the type of load and the direction of thrust. The 4-bolt flange centers the housing and distributes the load; the mounting surface should be flat and the bolts should be tightened in a cross pattern to avoid deforming the housing. Check the sealing: in dusty or wet environments, an additional seal extends bearing life. Lubrication is done through the housing's grease channel, and before tightening, verify shaft alignment with the rest of the line.

Mounted housings are interchanged between brands by shaft number, flange type and housing dimensions, not by the commercial code. If the equipment has a Link-Belt unit and you need to replace it, compare shaft diameter, hole spacing, center height and inner ring mounting type. MR Accesorios Industriales will indicate the compatible alternative within the B22400 series or equivalent lines, and also manufactures split plummer block housings when the mounting requires it.

If you already have the housing code or the shaft size, send it via WhatsApp to MR Accesorios Industriales and we will quote it promptly. We can also guide you if the equipment requires a flange variant, a different seal or a housing with another hole arrangement. With the model and a photo of the mounting, we resolve the inquiry without delay.