LINK-BELT AG355L insert bearing

LINK-BELT AG355L is a reference of insert bearing, within Bearings. Request a quote for AG355L via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The LINK-BELT 300 series insert bearing is a single-row bearing with an extended inner ring, designed to be mounted in split plummer block housings and take-up frames. It is used in equipment where the shaft rotates and the load combines moderate radial and axial forces, such as belt conveyors, elevators and mixers. MR Accesorios Industriales supplies this line.

The 300 series designation is read with the prefix AG followed by a three-digit number and the suffix L. The number identifies the insert size within the series: it is not a diameter or a direct measurement, but a catalogue code that correlates with the shaft diameter. Thus, AG319L, AG323L and AG327L are three different sizes of the same family. The suffix L distinguishes the sealing and configuration variant of the insert. To choose the right one, send us the complete code or the shaft measurement.

These inserts are mounted in split plummer block housings, take-up frames and split housings used in food, cement, aggregates and water treatment plants. In Argentina they appear in belt conveyors, bucket elevators, horizontal mixers and milling equipment. The combination of insert and split housing allows the bearing to be replaced without dismantling the shaft, which is key in continuous production lines where every minute of downtime counts.

To select correctly, take into account the shaft diameter, the type of load and the environmental conditions. The insert's sealing defines whether it withstands dust, water or frequent washdowns. Lubrication must be the one indicated for the working temperature, and mounting requires aligning the housing with the shaft to avoid lateral stresses. Correct tightening of the housing bolts and the use of suitable tools extend the service life of the assembly.

300 series insert bearings are available from several brands, and equivalences between manufacturers are established by shaft diameter, inner ring width and type of locking. It is not enough for the code to be similar: those critical dimensions must be compared. If you need to replace an insert from another brand, send us the old code and the shaft measurement, and we will indicate the compatible alternative within the LINK-BELT line.

At MR Accesorios Industriales we work with the LINK-BELT line and know the criteria so that the correct insert reaches your plant. If you already have the code AG319L, AG323L or any other in the series, write to us on WhatsApp and we will quote it shortly. We can also advise you if you need to assemble the unit with the appropriate split plummer block housing.