Y-bearing (insert bearing) INA RCSMB15/65-XL-FA106

INA RCSMB15/65-XL-FA106 is a y-bearing (insert bearing) reference, within Bearings. Request a quote for RCSMB15/65-XL-FA106 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The INA RCSMB-XL-FA Y-bearing is an insert with a spherical outer ring and screw locking system, designed to be mounted in split plummer block or flanged housings. It is used in equipment where the shaft rotates and requires alignment and sealing. MR Accesorios Industriales distributes this INA line in Buenos Aires, Argentina, with technical advice to choose the correct variant according to shaft diameter and housing type.

The RCSMB-XL-FA designation is read in blocks. RCSMB identifies the insert series with spherical outer ring and set screw locking. The number that follows, as in RCSMB15/65-XL-FA106 or RCSMB20/65-XL-FA106, indicates the shaft diameter and the insert outside diameter. The suffix XL corresponds to the optimized version of the series, and FA106 defines the sealing type and lubrication conditions. Knowing these codes allows you to order the exact replacement without ambiguity.

These bearings are used in conveyors, belts, elevators, mixers, mills and transmission equipment in food, chemical, cement and aggregate plants. In Argentina they are common in the meat industry, waste treatment plants and packaging lines, where the environment may have dust, moisture or frequent washdowns. Their mounting in split plummer block housings facilitates replacement without completely disassembling the shaft, which reduces downtime.

To select the insert, verify the shaft diameter and the housing type (split plummer block, flanged or take-up). The FA106 seal protects against contaminants and retains lubricant; if the equipment operates with washdowns or fine dust, it is advisable to check the condition of the lips and renew the grease according to the duty cycle. Housing alignment and uniform tightening of the set screws prevent parasitic loads and extend bearing life.

Y-bearings are interchangeable between manufacturers if the main dimensions match: shaft diameter, outside diameter, width and locking type. When requesting a quote, it is advisable to compare the complete designation, not just the diameter. INA, FAG, SKF, NSK and NTN offer equivalent lines, but sealing and lubrication suffixes may vary. MR Accesorios Industriales can guide you on the appropriate equivalent for your equipment.

If you need to replace a Y-bearing, send the complete part number or the shaft and housing dimensions via WhatsApp to MR Accesorios Industriales. We will reply shortly with the INA RCSMB-XL-FA alternative that corresponds to your application.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.