Y-bearing (insert bearing) INA 206-XL-KRR

INA 206-XL-KRR is a y-bearing (insert bearing) reference, within Bearings. Request a quote for 206-XL-KRR via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The Y-bearing is an insert with a spherical outer ring and an extended inner ring, designed to be mounted in split plummer block or flanged housings. The INA KRR series is recognized by its sealing and locking system. It is used in equipment where alignment is not perfect and rotating shafts must be supported with radial load and some axial load. MR Accesorios Industriales supplies this line for plants and workshops in Buenos Aires and the rest of the country.

The series designation combines a three-digit number that indicates the insert size and the suffix KRR, which defines the type of sealing and the locking system. For example, 202-XL-KRR and 203-XL-KRR correspond to the smallest sizes, while 210-XL-KRR covers the larger diameters in the series. The suffix XL identifies the current generation of the product. To choose the correct part number, have the shaft diameter and the type of housing where it will be mounted on hand.

These bearings are mounted in conveyors, mixers, fans, packaging belts and process equipment in general. In Argentina you will find them in food, chemical and meat processing plants and in the field, on seeders and harvesters. Also in maintenance workshops that replace worn inserts without changing the complete housing. The combination of a spherical outer ring and a split plummer block housing allows absorbing small misalignments typical of welded structures or sheet metal mountings.

To select correctly, verify that the shaft diameter matches the part number and that the housing is compatible with the outer ring. The KRR seal protects against dust and splashes, but does not replace additional protection in very dirty environments. During mounting, tighten the locking screws on the shaft with the corresponding wrench and verify that the insert can oscillate slightly inside the housing. Lubricate according to the operating conditions and check shaft alignment to avoid parasitic loads.

Y-inserts are interchangeable between manufacturers if the main dimensions match: shaft diameter, outer diameter and inner ring width. Equivalent series from other brands may vary in the type of sealing or the locking system, so it is best to compare the complete designation and not just the number. If the housing is already installed, the most practical option is to replace the insert with one of the same part number or with the equivalent we confirm for you.

If you need a quote for a Y-bearing of the KRR series, send us the complete part number by WhatsApp. You can also send us a photo of the insert or the housing and the shaft dimensions. At MR Accesorios Industriales we reply promptly with the available alternative.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.