DODGE WSTU-SCEZ-30M-PSS take-up bearing

DODGE WSTU-SCEZ-30M-PSS is a reference of take-up bearing, within Bearing housings. Request a quote for WSTU-SCEZ-30M-PSS via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DODGE SCEZ PSS series Y-bearing unit with insert bearing is a mounted take-up unit: it combines an insert ball bearing with a split cast iron housing, ready to mount on the shaft and fasten to the structure. It is used to guide and tension shafts in conveyors, belts and drive equipment, where a robust, self-aligning and easy-to-replace unit is required. MR Accesorios Industriales sells this line with technical advice to choose the correct size.

The SCEZ PSS series designation is read in blocks: WSTU identifies the housing type and its mounting configuration, SCEZ corresponds to the insert bearing series, and the number that follows — as in WSTU-SCEZ-20M-PSS or WSTU-SCEZ-35M-PSS — indicates the nominal shaft size. The M suffix indicates the insert-to-shaft locking variant, and PSS defines the sealing and the service conditions intended for the unit.

These units are found in food and beverage plants, material handling, packaging lines, aggregate processing equipment and package handling systems. In Argentina they appear in belt conveyors, bucket elevators, mixers, dryers and agricultural machinery, where the environment often has dust, moisture or frequent washdowns. The Y-bearing unit allows the shaft to be aligned with normal mounting tolerances and absorbs minor misalignment without requiring special machining on the structure.

To select the unit, start from the shaft diameter and confirm that the housing has the hole spacing and center height compatible with the base. Check the seal type according to the environment: in areas with water or fine dust, the reinforced sealing identified by the PSS suffix is preferable. During installation, clean the shaft seat, verify that the insert is properly locked and lubricate according to the duty cycle. Base alignment and even bolt tightening prevent parasitic loads and extend bearing life.

Mounted units are interchanged between manufacturers by part number and shaft size, but center height, hole spacing and locking type do not always match. Before replacing a unit, compare those dimensions and the sealing system; if space allows, an equivalent unit from another brand may work, although the interface with the shaft and the base should be verified. MR Accesorios Industriales will indicate the compatible alternative.

If you need to replace a unit or set up a new series, send the complete part number by WhatsApp — for example WSTU-SCEZ-25M-PSS — or the shaft size and housing dimensions. At MR Accesorios Industriales we will quote the DODGE reference and, if needed, offer the alternative that best suits your equipment.