Pillow block bearing DODGE TB-SCED-40M

DODGE TB-SCED-40M is a pillow block bearing reference, within Bearing housings. Request a quote for TB-SCED-40M via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DODGE SCED series pillow block with insert bearing is a mounted unit that combines a cast iron housing with an insert ball bearing, ready to bolt to the structure. It is used to support rotating shafts in equipment where simple alignment, retained lubrication and protection against dust and moisture are required. MR Accesorios Industriales supplies this line in Buenos Aires, Argentina, and advises you on choosing the correct size according to shaft diameter and operating conditions.

The SCED series designation is read in blocks: the letters identify the pillow block family with insert bearing, and the number after the hyphen indicates the shaft diameter in millimeters. Thus, TB-SCED-20M corresponds to a 20 mm shaft, TB-SCED-30M to a 30 mm shaft and TB-SCED-55M to a 55 mm shaft. The final M indicates the metric variant. This code defines the complete assembly: housing, insert, sealing and shaft locking system.

These pillow blocks appear in belt conveyors, bucket elevators, mixers, blowers, centrifugal pumps and packaging lines. In the Argentine market they are found in food plants, cement plants, tanneries, water treatment plants and metalworking shops. The cast iron housing absorbs radial loads and some axial thrust, and the ball insert allows moderate speeds with little maintenance. It is a common solution when the shaft needs intermediate support and there is no machined housing in the structure.

To select the pillow block, start with the shaft diameter and the type of load: predominantly radial, with some axial. Verify that the base sits flat and that the anchor bolts are properly tightened to avoid vibration. The insert sealing defines the working environment: in areas with coarse dust or water, additional protection is advisable. Lubrication comes from the factory and is replenished through the grease fitting; respect the interval according to service hours. Before mounting, align the shaft with the adjacent support so as not to load the insert sideways.

DODGE is a reference in mounted bearings and its nomenclature coexists with that of other brands in the field. When comparing alternatives, do not rely only on the code: cross-check shaft diameter, housing type, locking system and sealing. In many cases there is a direct equivalent, but interchangeability depends on the base and insert dimensions. If you need to replace an existing pillow block, send us the code stamped on the housing or the shaft size and we will indicate the compatible alternative.

MR Accesorios Industriales supplies the DODGE line in Buenos Aires, Argentina, with more than 80 years of experience in the field. If you are looking for an SCED pillow block for a 20, 25, 30, 35, 40, 45, 50 or 55 mm shaft, write to us on WhatsApp with the code or size and we will quote you promptly. We can also advise you on mounting and lubrication so that the assembly runs aligned and without vibration.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.