Hanger bearing DODGE SCHB-DL-111

DODGE SCHB-DL-111 is a hanger bearing reference, within Bearing housings. Request a quote for SCHB-DL-111 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DODGE D-Lok series hanger unit is a mounted bearing with a split housing, designed to support drive shafts at intermediate points where there is no continuous support structure. It is installed hanging from a threaded rod or a fixed support, and allows the shaft to rotate with controlled alignment. It is a common solution in conveyors, elevators and process lines where the span between supports is long. MR Accesorios Industriales sells this DODGE line in Buenos Aires, Argentina.

The SCHB-DL designation follows a clear logic: SCHB identifies the hanger unit assembly with insert bearing, DL corresponds to the D-Lok series, and the final number indicates the nominal shaft diameter in hundredths of an inch. Thus, SCHB-DL-100 is for a 1" shaft, SCHB-DL-102 for 1 1/8", SCHB-DL-103 for 1 3/16" and SCHB-DL-104 for 1 1/4". The codes SCHB-DL-106, SCHB-DL-107, SCHB-DL-108 and SCHB-DL-111 cover the following sizes in the series. The D-Lok system locks the insert to the shaft with an eccentric collar that locks in the direction of rotation.

In Argentine industry, these units appear in belt and chain conveyors, bucket elevators, augers, mixers and packaging lines. They are chosen when the shaft needs an intermediate support that cannot rest on the floor or on the side structure, for example in long equipment or hard-to-reach areas. They are also used in food, cement, aggregate and waste treatment plants, where the environment demands a robust mounting with simple maintenance.

To select the unit, start from the shaft diameter and verify the radial load that the hanger point will support. The D-Lok insert has a contact seal that retains grease and blocks dust and moisture; in very dirty environments or with frequent washdowns, it is advisable to check the condition of the seal and relubricate according to the duty cycle. Mounting requires aligning the unit with the shaft, tightening the collar in the direction of rotation and checking that the housing is free to oscillate. Poor alignment accelerates wear on the insert and the seal.

The DODGE D-Lok series is generally interchangeable with other brands of insert mounted bearings such as SKF, NSK, NTN or Timken when the shaft diameter, locking type and housing dimensions match. It is not enough for the code to be similar: you must compare the shaft diameter, the locking system and the distance between mounting centers. If you have doubts, send us the original code and we will indicate the compatible alternative.

If you need a DODGE D-Lok series hanger unit, write to us on WhatsApp with the code SCHB-DL and the shaft size. At MR Accesorios Industriales we will quote it promptly and, if you are looking for a variant that is not listed, we will source it or offer you the equivalent option. We can also advise you on mounting and lubrication so the unit works under the correct conditions.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.