Pillow block bearing DODGE P2B-SXRBAG-55M

DODGE P2B-SXRBAG-55M is a pillow block bearing reference, within Bearing housings. Request a quote for P2B-SXRBAG-55M via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DODGE SXRB AG series pillow block with insert bearing is an assembled unit that combines a cast iron housing with an insert ball bearing, ready to be fixed onto a flat base. It is used to support transmission shafts in equipment where rigidity, alignment and protection against dust and humidity are needed. MR Accesorios Industriales sells this line in Buenos Aires, Argentina, and advises you to choose the correct size according to your shaft.

The designation of these pillow blocks is read in blocks: the initial P indicates pillow block, the number that follows defines the housing size and the letter B confirms the mounting configuration. The SXRB AG block identifies the insert bearing family with its sealing and locking characteristics, and the final suffix with M corresponds to the nominal shaft size in millimeters. Thus, references such as P2B-SXRBAG-20M or P2B-SXRBAG-40M share the housing and change the fit diameter. The ER-Series accompanies this line with insert variants.

These pillow blocks appear in belt conveyors, sorting belts, mixers, blowers, centrifugal pumps and packaging lines. In the Argentine market they are found in food plants, meatpacking plants, cement plants, tanneries and agricultural facilities, where frequent washdown and dust demand reliable sealing. The cast iron housing withstands the weather and the insert bearing absorbs small shaft misalignments, which simplifies maintenance in equipment that runs many hours per day.

To select the pillow block, start from the shaft diameter you need and verify the distance between mounting holes and the height to center. Check the type of sealing according to the environment: single contact for clean interiors, labyrinth or reinforced seal for areas with water or particles. During mounting, support the base on a machined surface, tighten the screws in a cross pattern and verify alignment with a straightedge or dial indicator. Lubricate the insert with the specified grease and check radial clearance before starting the equipment.

The dimensions of these pillow blocks follow standard dimensional norms, so they are usually interchangeable with equivalent units from other brands that use the same housing and shaft nomenclature. Interchangeability depends on shaft diameter, distance between holes and height to center, not only on the code. If your equipment has another brand, send us the code engraved on the housing or the shaft diameter and we will indicate the compatible alternative from the DODGE line.

If you need to replace a pillow block or set up a complete line, write to us on WhatsApp with the code P2B-SXRBAG-... or with the shaft and base dimensions. At MR Accesorios Industriales we will quote the corresponding reference and support you in choosing the sealing and lubrication so the mounting lasts. More than 80 years of industrial experience in Buenos Aires, Argentina, back every advisory.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.