Pillow block bearing DODGE P2B-SCBED-204L

DODGE P2B-SCBED-204L is a pillow block bearing reference, within Bearing housings. Request a quote for P2B-SCBED-204L via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The SCBED series pillow block is a pillow block mounted bearing: a unit that combines a cast iron housing with a ball insert bearing, already assembled and aligned at the factory. It is used to support drive shafts on a flat base, with two mounting holes, in equipment where radial load must be supported and rotation allowed with low maintenance. MR Accesorios Industriales supplies the DODGE brand in Buenos Aires, Argentina.

The SCBED series designation is read in blocks. The prefix P2B indicates a two-bolt pillow block; SCBED identifies the housing family and its shaft locking system. The final numeric suffix, as in P2B-SCBED-008L, P2B-SCBED-010L, P2B-SCBED-110L, P2B-SCBED-200L and P2B-SCBED-204L, references the shaft size for which the insert is assembled. The final letter L distinguishes the sealing variant or housing configuration within the same series.

These housings appear in belt and roller conveyors, bucket elevators, mixers, mills, packaging belts and process lines in food, chemical and aggregate plants. In Argentina they are widely seen in material handling equipment and in machines that work with long shafts supported at several points. Being assembled units, they simplify mounting: they are fastened to the base and the shaft enters the insert without the need to press the bearing and housing separately.

To choose well, take into account the shaft diameter and configuration, the type of load (radial, axial or combined) and the environmental conditions. The insert sealing defines how much contamination it tolerates: in dusty or wet environments, tighter protection is advisable. Check the alignment of the base and the shaft support before tightening the bolts, and lubricate according to the duty cycle. A misaligned housing shortens the life of the insert even when the load is low.

As for interchangeability, mounted housings are compared by shaft size, housing type and locking system. Between brands, the center height, hole spacing and sealing may vary, so replacement is validated with those dimensions and not only with the code. If you need to replace a housing from another brand, send us the code or the dimensions and we will point you to the compatible alternative.

If you have the housing code, the shaft size or a photo of the nameplate, send it by WhatsApp to MR Accesorios Industriales. We will quote the DODGE reference you need or the alternative that best suits your equipment, and we will reply promptly.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.