Pillow block bearing DODGE P2B-GTUAH-15

DODGE P2B-GTUAH-15 is a pillow block bearing reference, within Bearing housings. Request a quote for P2B-GTUAH-15 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DODGE Y-bearing pillow block from the P2B-GTUAH line is a mounted foot assembly: a cast housing with two mounting holes and an insert ball bearing, pre-assembled and aligned at the factory. It is used to support transmission shafts in equipment where rigidity, easy replacement and a pivot point that absorbs minor misalignment are required. MR Accesorios Industriales sells this brand in Buenos Aires, Argentina.

The designation is read in blocks. P2B identifies the two-bolt pillow block; GTUAH defines the housing, the insert locking system and the sealing; the final numeric segment indicates the shaft size, as in P2B-GTUAH-03, P2B-GTUAH-06 or P2B-GTUAH-010. Three-digit suffixes usually correspond to the inch sizes of the ER-Series, while two-digit ones cover the equivalent metric diameters. By providing the full part number, the variant you need is identified unambiguously.

These pillow blocks appear in belt conveyors, bucket elevators, mixers, screens, fans and packaging lines. In food plants, cement plants, feed lots and treatment plants they are chosen for the combination of stamped steel or cast housing, contact seals and the possibility of regreasing. They are also used in agriculture, in screw conveyors and norias, where dust and weather punish the supports.

For selection, take into account the shaft diameter, the type of shaft locking (set screw, cone or adapter), the sealing required according to the environment, and the radial and axial load of the equipment. During mounting, seat the pillow block on a flat, rigid base, align the two holes and tighten the mounting bolts without forcing the housing. Lubricate according to the duty cycle and check the axial play before starting up.

Among brands, pillow blocks with insert bearings are interchanged by shaft size, housing type and locking system, not by the commercial part number. The same size may appear as P2B, SY, UCP or similar depending on the manufacturer; what matters is the diameter, the insert width and the hole spacing. If in doubt, send a photo of the housing or the old part number and we'll cross-reference it.

To wrap up, if you already have the pillow block part number or the shaft size, write to MR Accesorios Industriales on WhatsApp and we'll quote it promptly. If you're looking for a variant you don't see, send us the model or the size and we'll point you to the compatible alternative within the DODGE line or its equivalent.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.