DODGE P2B-GTUAH-03 pillow block bearing

DODGE P2B-GTUAH-03 is a reference of pillow block bearing, within Bearing housings. Request a quote for P2B-GTUAH-03 via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DODGE Y-bearing pillow block with insert bearing of the P2B-GTUAH line is a mounted pillow block assembly: a cast iron housing with two mounting holes and an insert ball bearing, already assembled and aligned at the factory. It is used to support transmission shafts in equipment where rigidity, easy replacement and a pivot point that absorbs small misalignments are needed. MR Accesorios Industriales sells this brand in Buenos Aires, Argentina.

The designation is read in blocks. P2B identifies the two-bolt pillow block housing; GTUAH defines the body, the insert locking system and the sealing; the final numeric section indicates the shaft size, as in P2B-GTUAH-03, P2B-GTUAH-06 or P2B-GTUAH-010. The suffixes with three digits usually correspond to the inch sizes of the ER-Series, while the two-digit ones cover the equivalent metric diameters. By sending the complete code, the variant you need is identified without ambiguity.

These pillow blocks appear in belt conveyors, bucket elevators, mixers, screens, fans and packaging lines. In food, cement, feedlot and treatment plants they are chosen for the combination of stamped steel plate or cast iron, contact seals and the possibility of regreasing. They are also used in agriculture, in screw conveyors and bucket elevators, where dust and weather punish the supports.

To select, take into account the shaft diameter, the type of locking on the shaft (set screw, cone or adapter), the sealing required according to the environment and the radial and axial load of the equipment. During mounting, rest the pillow block on a flat, rigid base, align the two holes and tighten the fastening bolts without forcing the housing. Lubricate according to the duty cycle and check the axial clearance before starting up.

Between brands, pillow blocks with insert bearing are interchanged by shaft size, housing type and locking system, not by the commercial code. The same size may appear as P2B, SY, UCP or similar depending on the manufacturer; what matters is the diameter, the insert width and the hole spacing. If in doubt, send a photo of the nameplate or the old code and we will cross-reference it.

To close, if you already have the pillow block code or the shaft size, write to us by WhatsApp at MR Accesorios Industriales and we will quote it shortly. If you are looking for a variant you do not see, send us the model or the size and we will indicate the compatible alternative within the DODGE line or its equivalent.