Pillow block bearing DODGE P2B-GTAH-115

DODGE P2B-GTAH-115 is a pillow block bearing reference, within Bearing housings. Request a quote for P2B-GTAH-115 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DODGE GTAH pillow block is a mounted pillow block with an ER-Series insert bearing. It is used to support rotating shafts in drive and conveyor equipment, where alignment and sealing are critical. Its split or solid design, depending on the model, simplifies assembly and in-plant maintenance. MR Accesorios Industriales carries this brand with more than 80 years of experience in Buenos Aires, Argentina.

The GTAH series designation is read in blocks: the letter P indicates a pillow block, the number that follows defines the housing size, and the GTAH suffix identifies the housing and insert configuration. For example, P2B-GTAH-03 corresponds to a two-bolt pillow block with an ER-Series insert bearing for a 3/4 inch shaft, while P2B-GTAH-008 and P2B-GTAH-08 refer to nominal sizes of 1/2 and 1 inch respectively. The final numeric suffixes indicate the shaft diameter in inches or its metric equivalent depending on the series.

These pillow blocks are used in belt conveyors, bucket elevators, mixers, mills and process equipment in the food, chemical, cement and aggregate industries. In Argentina they are common in animal feed plants, aggregate processing plants and packaging lines, where the environment can be dusty or humid. The gray cast iron housing with protective coating and the insert with labyrinth-type sealing offer resistance to contamination and weather.

To select the correct pillow block, take into account the shaft diameter, the expected radial and axial load, and the environmental conditions. The ER-Series insert allows limited initial misalignment; verify alignment between pillow blocks to avoid parasitic loads. Factory lubrication may require replenishment depending on the duty cycle: use grease compatible with the seal. During assembly, tighten the insert set screws to the shaft with the appropriate wrench and check radial clearance after tightening the housing.

Cross-brand equivalences are established by mounting dimensions: shaft diameter, bolt hole spacing, center height and mounting type. A DODGE GTAH pillow block can be interchanged with other brands that follow the corresponding mounting standard, but always verify the housing dimensions and the insert load capacity. MR Accesorios Industriales advises you to find the alternative compatible with your equipment.

If you need a pillow block with insert bearing for your application, send the part number or dimensions via WhatsApp to MR Accesorios Industriales. We will quote you promptly and indicate the option that best suits your shaft and working conditions.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.