DODGE P2B-GTAH-104S pillow block bearing

DODGE P2B-GTAH-104S is a reference of pillow block bearing, within Bearing housings. Request a quote for P2B-GTAH-104S via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DODGE ER-Series pillow block with insert bearing is a mounted unit that combines a cast housing with an insert ball bearing, ready to fasten to a flat base. It is used to guide and support rotating shafts in power transmission equipment, reducing friction and absorbing radial loads. Its pillow block design makes it easy to align the shaft and mount it on steel or concrete structures.

The designation P…B-GTAH-…S is read in blocks: the P indicates a pillow block; the number that follows defines the size; B corresponds to the housing series; GTAH identifies the insert bearing with its sealing and locking features; and the final S indicates the mounting variant. A specific example is P2B-GTAH-104S, where the 2 and the 104 refer to the size of the unit. To request a quote, send us the full code shown on the nameplate or on the equipment.

These pillow blocks are used in belt conveyors, bucket elevators, mixers, mills, centrifugal pumps and industrial fans. In Argentina they are common in food plants, cement plants, tanneries, water treatment plants and agro-industrial facilities. The cast housing withstands environments with dust and moderate moisture, and the insert with labyrinth seal protects the lubricant under continuous operating conditions.

To select the pillow block, take into account the shaft diameter, the expected radial and axial load, and the insert locking type. Check that the base is perfectly flat and aligned before tightening the bolts; poor alignment accelerates bearing wear. Factory lubrication is usually sufficient for start-up, but in demanding environments it is advisable to check the condition of the seal and relubricate according to the duty cycle.

Insert bearing pillow blocks are interchangeable between brands if the mounting dimensions, shaft diameter and locking type match. Equivalent series from other manufacturers may differ in the sealing system or in the insert locking method, so it is advisable to verify the center height, the hole spacing and the shaft diameter before replacing. MR Accesorios Industriales will tell you the compatible alternative.

If you need to replace a DODGE ER-Series pillow block, send us the code stamped on the housing or the equipment model on WhatsApp. At MR Accesorios Industriales we will quote it and tell you the compatible alternative. We also manufacture split plummer block housings and custom special parts. Write to us with the code or model you need and we will reply promptly.