DODGE P2B-DLUEZ-102-SHCR pillow block bearing

DODGE P2B-DLUEZ-102-SHCR is a reference of pillow block bearing, within Bearing housings. Request a quote for P2B-DLUEZ-102-SHCR via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DODGE Y-bearing with insert from the DLUEZ series is a pillow block mounted unit: it combines an insert ball bearing with a split housing that is fixed to the structure. It is used to support rotating shafts in drive, conveying and process equipment, where a compact and easy-to-mount solution is needed. MR Accesorios Industriales sells this line and advises you on choosing the right variant for your application.

The designation of the DLUEZ series is read in blocks. The prefix P2B indicates the split pillow block housing type; DLUEZ identifies the insert bearing series, with sealing and characteristics specific to the line; the following numbers correspond to the shaft diameter in inches according to the series table. The suffix SHCR indicates a specific construction variant within the family. With the full part number, the unit you need is identified unambiguously.

These housings are seen in belt conveyors, bucket elevators, mixers, mills, screens and process equipment in food, chemical and aggregate plants. In Argentina they are common in the oilseed industry, in feed plants and in packaging lines, where the environment may have dust, moisture or frequent washdowns. The split housing makes assembly and replacement of the insert easier without completely disassembling the shaft, which is key when the equipment runs on scheduled shutdowns.

To select correctly, take into account the shaft diameter, the load type and the environmental conditions. The insert seal defines the protection against dust and water: choose the right variant if there are washdowns or fine particles. Lubrication of the insert bearing is permanent from the factory, but it is advisable to check the condition of the seal at each maintenance interval. When mounting, verify the alignment of the housing with the shaft and the flat support of the base; poor alignment accelerates wear of the insert and the seal.

Within the family of mounted units, series from different brands are often interchangeable if the shaft diameter, housing type and mounting dimensions match. It is not enough for the part number to be similar: you must compare the base geometry, the height to center and the insert locking system. If your equipment has a DODGE DLUEZ unit, we can indicate the compatible alternative or source the exact reference you need.

If you have the part number of the unit you are replacing, send it by WhatsApp to MR Accesorios Industriales along with a photo of the housing and the shaft measurement. With that data we will quote you the corresponding DODGE reference or the alternative that best suits your equipment. We can also advise you if you need to change the housing type or seal to improve performance in a demanding environment.