Pillow block bearing DODGE P2B-DLM-203

DODGE P2B-DLM-203 is a pillow block bearing reference, within Bearing housings. Request a quote for P2B-DLM-203 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DLM series Y-bearing with insert is a pillow block bearing unit: the unit combines a split cast iron housing with a ball insert that is fixed to the shaft by means of the D-Lok system. It is used to support transmission shafts in equipment where rigidity, easy mounting and good protection against dust and moisture are required. MR Accesorios Industriales supplies this DODGE line in Buenos Aires, Argentina.

The designation is read in blocks. The letters P2B indicate a two-bolt split pillow block; DLM identifies the housing and insert series; the final number indicates the shaft size, as in P2B-DLM-100, P2B-DLM-103 or P2B-DLM-115. The D-Lok suffix corresponds to the system that fixes the insert to the shaft, which replaces the classic set screws and simplifies adjustment on site.

These bearing units appear in belt and roller conveyors, packaging lines, mixers, blowers, centrifugal pumps, screens and milling lines. In Argentina they are found in food plants, cement plants, cold storage facilities, tanneries and aggregate processing facilities, where an environment loaded with dust or moisture demands a robust housing and a well-sealed insert.

To select correctly, take into account the shaft diameter and tolerance, the expected radial and axial load, and the type of sealing according to the environment: abrasive dust, frequent washdown or permanent moisture. During mounting, seat the bearing unit on a flat, rigid base, align the two halves before tightening the bolts and check the insert clearance. Lubricate according to the duty cycle and check shaft alignment so as not to stress the insert.

Mounted units are interchanged between brands by their dimensional designation: a two-bolt split pillow block for a given shaft is usually compatible between manufacturers, although the fixing system, the sealing and the housing height change. Always compare the shaft size, the outer diameter, the bolt spacing and the center height before replacing one unit with another.

If you need to replace a Y-bearing with insert or set up a new line, send the part number shown on the nameplate or on the part on WhatsApp, for example P2B-DLM-104, and at MR Accesorios Industriales we will quote you promptly. We will also indicate the compatible alternative if you are looking for another variant of the DLM series.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.