DODGE P2B-DLEZ-104S-SHCR pillow block bearing

DODGE P2B-DLEZ-104S-SHCR is a reference of pillow block bearing, within Bearing housings. Request a quote for P2B-DLEZ-104S-SHCR via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DODGE DLEZ series pillow block is a mounted bearing unit: a unit that combines a cast iron housing with an insert ball bearing, already assembled and aligned at the factory. It is used to support rotating shafts in equipment where a robust unit, simple mounting and good self-aligning capability are required. MR Accesorios Industriales supplies this line as a brand and advises you on choosing the correct variant for your shaft.

The DLEZ series designation is read in blocks. In a part number such as P2B-DLEZ-104S-SHCR, the first letters and the number indicate the housing type and its mounting configuration; DLEZ identifies the insert and housing family; the number that follows, such as 104, corresponds to the nominal shaft diameter in inches; and the final suffixes, such as S and SHCR, indicate construction variants: seal type, shaft locking and housing details. With the complete part number the unit you need is identified unambiguously.

These housings appear in belt and roller conveyors, packaging lines, mixers, blowers, exhausters, milling lines and process equipment in food, chemical and materials plants. In Argentina they are widely seen in the meat industry, in balanced feed plants and in bulk material handling, where a humid or dusty environment requires a closed housing and a well-sealed insert.

To select the unit, start from the shaft diameter and the type of load: predominantly radial in most conveyors, with some axial depending on the application. Check the sealing, because in environments with water or fine dust an insert with a reinforced seal is advisable. During mounting, support the housing on a flat, rigid base, tighten the bolts without forcing the housing and check shaft alignment before securing. The insert is lubricated with grease and the interval depends on the speed and working temperature.

Mounted units of this type are interchangeable between manufacturers when the shaft diameter, center height, hole spacing and locking type match. In practice, a complete unit is often replaced by another brand with the same configuration, or only the insert is changed if the housing is in good condition. For that, it is advisable to compare the main dimensions and the insert locking system on the shaft, not just the commercial part number.

If you have the part number of the unit you are replacing, send it via WhatsApp to MR Accesorios Industriales along with the shaft diameter and a photo of the mounting. We will quote the equivalent DODGE reference and, if necessary, indicate the compatible alternative from another brand with the same mounting dimensions.