Flange bearing 2 holes DODGE LFT-SC-35M-NL

DODGE LFT-SC-35M-NL is a flange bearing 2 holes reference, within Bearing housings. Request a quote for LFT-SC-35M-NL via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DODGE SC series 2-bolt flange Y-bearing unit with insert bearing is a mounted assembly that combines a cast iron housing with an insert ball bearing, already aligned and lubricated from the factory. It bolts onto a flat surface and supports the shaft in applications that require rigid, low-profile mounting, with the shaft passing through or at the end. MR Accesorios Industriales supplies this line in Buenos Aires, Argentina.

The SC series designation is read in blocks: LFT identifies the 2-bolt flange housing, SC the insert series, the number after the hyphen is the nominal shaft diameter and the final letters indicate sealing or configuration variants. Thus, LFT-SC-17M-NL, LFT-SC-20M-NL and LFT-SC-25M-NL are the same housing for different shaft sizes, and the same applies to LFT-SC-30M-NL and LFT-SC-35M-NL. The M suffix indicates the insert version and NL the closure type; it is best to respect them when ordering the replacement.

In Argentine industry these housings appear in belt and roller conveyors, mixers, screens, bucket elevators, packaging lines and water treatment equipment. They are also used in centrifugal fans, pumps and agricultural machinery, where the 2-bolt flange allows mounting on folded sheet metal or profiled structures without machining. Being self-aligning units, they tolerate small shaft misalignments relative to the base.

To select the housing, start from the shaft diameter and the type of load: the SC series is the medium-duty section within the insert bearing line. Check the sealing according to the environment: in areas with dust, water or frequent washing, a more sealed closure than the standard one is advisable. During mounting, rest the flange on a clean, flat surface, tighten the bolts in a cross pattern and check that the shaft turns freely. Lubricate according to the duty cycle and check alignment before start-up.

The dimensions of flanged insert housings correspond between manufacturers, but the part numbers are not directly interchangeable: the sealing, the shaft locking system and the housing height change. When replacing a unit, compare shaft diameter, hole spacing and closure type, not just the number. If the original housing is not available, we will indicate the compatible alternative with those same dimensions.

If you already have the housing part number, send it by WhatsApp to MR Accesorios Industriales along with the shaft diameter and a photo of the mounting. With that we will quote the unit and, if needed, the associated inserts and accessories. We work with the DODGE line and with equivalent alternatives so that the machine is back in production shortly.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.