DODGE LFT-SC-17M-NL flange bearing 2 holes

DODGE LFT-SC-17M-NL is a reference of flange bearing 2 holes, within Bearing housings. Request a quote for LFT-SC-17M-NL via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DODGE SC series 2-bolt flange Y-bearing unit with insert bearing is a mounted set that combines a cast iron housing with an insert ball bearing, already aligned and lubricated at the factory. It is bolted onto a flat face and supports the shaft in applications where rigid, low-profile mounting is required, with the shaft through or at the end. MR Accesorios Industriales sells this line in Buenos Aires, Argentina.

The designation of the SC series is read in blocks: LFT identifies the 2-bolt flange housing, SC the insert series, the number after the hyphen is the nominal shaft diameter and the final letters indicate sealing or configuration variants. Thus, the part numbers in the series share the same housing and change the shaft diameter. The suffix M indicates the insert version and NL the closure type; it is advisable to respect them when ordering the replacement.

In Argentine industry these housings appear in belt and roller conveyors, mixers, screens, bucket elevators, packaging lines and water treatment equipment. They are also used in centrifugal fans, pumps and agricultural machinery, where the 2-bolt flange allows mounting on folded sheet metal or profile structures without machining. Being self-aligning units, they tolerate small misalignments of the shaft with respect to the base.

To select the housing, start from the shaft diameter and the type of load: the SC series is the medium-section one within the insert bearing line. Check the sealing according to the environment: in areas with dust, water or frequent washing, a more sealed closure than the standard one is advisable. During mounting, rest the flange on a clean, flat surface, tighten the screws in a cross pattern and check that the shaft turns freely. Lubricate according to the duty cycle and check the alignment before starting up.

The dimensions of flange insert housings correspond between manufacturers, but the part numbers are not directly interchangeable: the sealing, the shaft locking system and the housing height change. When replacing a unit, compare shaft diameter, distance between holes and closure type, not just the number. We tell you the alternative compatible with those same dimensions.

If you already have the housing part number, send it by WhatsApp to MR Accesorios Industriales along with the shaft diameter and a photo of the mounting. With that we will quote the unit and, if needed, the associated inserts and accessories. We work with the DODGE line and with equivalent alternatives so that the machine is back in production promptly.