DODGE LF-SC-015 flange bearing 3 holes

DODGE LF-SC-015 is a reference of flange bearing 3 holes, within Bearing housings. Request a quote for LF-SC-015 via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DODGE LF-SC series 3-bolt flange housing is a mounted ball insert bearing designed to secure rotating shafts to flat structures. It bolts down at three points, which provides stable support and makes shaft alignment easy. It is used in equipment where the mounting must be compact and resistant to moderate radial loads. MR Accesorios Industriales sells this line in Buenos Aires, Argentina, with technical advice to choose the right size.

The LF-SC-… designation is read in parts: LF indicates the flange housing type, SC corresponds to the insert bearing series, and the final number identifies the shaft diameter size. The final numbers cover shafts of different dimensions. Numerical suffixes usually indicate construction variants within the same series, such as the sealing type or the insert material. It is always best to verify the full part number before requesting a quote.

These housings are used in belt conveyors, bucket elevators, mixers, fans and packaging lines. In Argentine industry they appear in food plants, cement plants, cold storage facilities and grain warehouses, where the environment demands protection against dust and moisture. They are also mounted on pumping equipment and agricultural machinery. Their three-bolt flange makes installation on sheet metal or profiles easy, and the insert bearing tolerates slight misalignment without losing performance.

To select the housing, take into account the shaft diameter, the radial load and the environmental conditions. The insert seal defines resistance to water, dust and chemical agents: choose single-lip seals for dry environments and reinforced seals for frequent washdowns. Lubrication must be the one specified by the manufacturer and should be checked at every maintenance interval. During mounting, align the three holes and tighten the bolts evenly to avoid deformation. Careful mounting extends bearing life.

DODGE SC series housings are interchangeable with other brands that use the same flange standard and shaft diameter. Equivalences are established by standardized dimensions, not by the commercial part number. If you need to replace an existing housing, send us the part number stamped on the part or the shaft dimensions and the distance between holes. At MR Accesorios Industriales we tell you the compatible alternative and quote you on WhatsApp promptly.

MR Accesorios Industriales sells the DODGE line. If you are looking for a 3-bolt flange housing for your equipment, write to us on WhatsApp with the part number or the dimensions you need. We quote you promptly and advise you so that the mounting is correct.