Flange bearing 3 holes DODGE LF-GT-04

DODGE LF-GT-04 is a flange bearing 3 holes reference, within Bearing housings. Request a quote for LF-GT-04 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DODGE LF-GT Y-bearing flange unit is a 3-bolt flange mounted bearing. It is used to support rotating shafts on metal structures, with the advantage of a flange that bolts directly and allows mounting the assembly without machining the base. It is a common solution in power transmission equipment where a compact, self-aligning support that is easy to replace is needed. MR Accesorios Industriales sells it in Buenos Aires, Argentina.

The LF-GT designation is read in parts: LF identifies the 3-bolt flange, GT is the insert bearing series and the final number indicates the nominal shaft diameter. For example, LF-GT-03 corresponds to a 3/4" shaft, LF-GT-04 to 1", LF-GT-05 to 1 1/4", LF-GT-06 to 1 1/2", LF-GT-07 to 1 3/4", LF-GT-008 to 1", LF-GT-010 to 1 1/4" and LF-GT-012 to 1 1/2". Suffixes may indicate sealing or locking variants, which are confirmed when requesting a quote.

In Argentine industry, these units appear in belt conveyors, bucket elevators, mixers, screens and packaging lines. They are also found in agricultural equipment, such as augers and norias, and in aggregate processing plants. The 3-bolt flange makes mounting on folded sheet metal or profiles easier, and the self-aligning insert absorbs small misalignments between supports.

To select the unit, take into account the shaft diameter, the type of load (radial, axial or combined) and the environmental conditions. If there is dust, water or frequent washdowns, a reinforced seal is advisable. Mounting requires the flange to sit flat and the bolts to be tightened evenly. The insert is lubricated with good quality grease and the internal clearance is not adjusted: the bearing is calibrated at the factory.

DODGE LF-GT series units are interchangeable with other brands of 3-bolt flange mounted bearings that share the same shaft diameter and hole pattern. When replacing, always verify the critical dimensions: shaft diameter, hole spacing and overall height. If the original code does not match, a compatible alternative with the same performance can be adapted.

If you need to replace a Y-bearing flange unit, send the complete code by WhatsApp to MR Accesorios Industriales. We will quote the exact reference or the compatible alternative for your application. We also advise on mounting and lubrication so the assembly runs aligned and without vibration.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.