DODGE INS-SXRH-60M insert bearing

DODGE INS-SXRH-60M is a reference of insert bearing, within Bearings. Request a quote for INS-SXRH-60M via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The Dodge SXRH series insert bearing is a ball bearing with an extended inner ring, designed to be mounted in split plummer block housings and wall units. It is used when the insert must be replaced without changing the housing, or to build equipment with a split housing. MR Accesorios Industriales sells this brand line and advises you on choosing the correct part number for your application.

The SXRH series designation is read from the full part number: for example, INS-SXRH-30M or INS-SXRH-45M. The letters SXRH identify the Dodge family of inserts for split plummer block housings; the number that follows indicates the shaft diameter in millimeters, and the final M distinguishes the sealing and locking variant. Thus, the number after SXRH corresponds to the shaft diameter in millimeters. By sending the full part number on WhatsApp, we will quote the exact reference.

These inserts are seen in belt conveyors, bucket elevators, mixers, mills and process equipment in food, chemical and aggregate plants. Also in agricultural machinery and packaging lines. In Argentina, where dust and humidity punish mountings, the insert with good sealing and simple replacement is a common maintenance solution. MR Accesorios Industriales supports plants throughout the country with this line.

To select the insert, check the shaft diameter and the type of housing where it is seated. Sealing is key: in environments with dust or water, a variant with a reinforced seal is advisable. When mounting, clean the seat, check that the shaft has no burrs and tighten the locking set screws with the proper wrench. Factory lubrication is usually enough for the service life, but under severe conditions you can relubricate if the insert has a lubrication passage. Alignment between housings prevents lateral loads.

As for equivalents, Dodge SXRH series inserts can be interchanged with other brands that use the same millimeter diameter nomenclature and a similar outer ring configuration. There is no universal table: interchangeability depends on the housing dimensions and the locking system. If you send us the original part number or the shaft and housing dimensions, we will indicate the compatible alternative within what we sell.

If you need to replace a Dodge SXRH insert, send us the full part number on WhatsApp: INS-SXRH-30M, INS-SXRH-55M or whichever applies. We will quote it shortly and, if you are looking for a variant that is not listed, write to us with the model or the dimensions and we will guide you. MR Accesorios Industriales works with this line so that your equipment keeps running.