Insert bearing DODGE INS-GT-107

DODGE INS-GT-107 is a insert bearing reference, within Bearings. Request a quote for INS-GT-107 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DODGE ER series insert bearing is a ball bearing with an extended inner ring, designed to be mounted in split plummer block housings and wall or floor-mounted units. It is used when the shaft needs to rotate supported by a removable assembly, with the possibility of securing the insert to the shaft and seating it in a split housing. MR Accesorios Industriales supplies it in Buenos Aires, Argentina, for equipment maintenance and replacement.

The designation of these inserts combines the series with a number indicating the size: examples range from INS-GT-03 to INS-GT-09, including INS-GT-008, and each corresponds to a different shaft diameter within the same family. The ER code identifies the Dodge Mounted Ball Bearings catalogue series, and the GT suffix accompanies the commercial code. To order the correct one, simply provide the full part number as it appears on the equipment or drawing.

They are common in belt conveyors, bucket elevators, mixers, screens, packaging lines and continuous process lines. In food, cement, grain and aggregate plants in Argentina they are found in equipment where the housing is bolted to the structure and the shaft is supported by the insert. They also appear in fans, pumps and low- and medium-speed machines with moderate load.

To select correctly, consider the shaft diameter, the shaft locking method and the sealing required by the environment. In dusty or wet areas, an insert with contact seals and an additional lip seal is preferable; in clean applications, a simple seal is sufficient. Installation requires cleaning the seat, aligning the housing with the shaft and tightening the locking device without striking the ring. Lubrication is replenished according to the duty cycle and the internal clearance is not modified on site.

Among brands, inserts of equivalent series can often be interchanged if the shaft diameter, inner ring width and locking system match. It is not advisable to rely on the part number alone: those three dimensions and the type of sealing must be compared. If the original insert is not available, at MR Accesorios Industriales we will indicate the alternative compatible with the assembly dimensions.

If you have the insert part number, the shaft size or a photo of the housing, send it by WhatsApp to MR Accesorios Industriales and we will quote it promptly. We can also look at the sealing or locking variant that best suits the equipment. With that data we prepare a straightforward response.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.