DODGE FC-SCED-104S piloted flange bearing

DODGE FC-SCED-104S is a reference of piloted flange bearing, within Bearing housings. Request a quote for FC-SCED-104S via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DODGE SCED series piloted flange bearing housing with insert bearing is an assembled unit that combines a cast iron housing with a circular flange and an insert ball bearing, already mounted and ready to bolt onto the machine structure. It is used to support drive shafts in equipment where a front mounting with good centering is required, such as conveyors, mixers, pumps and conveyors.

The designation of these housings is read in blocks: the initial letters identify the housing type and its mounting configuration, and the numeric suffix indicates the shaft diameter for which the insert is assembled. In the SCED series, for example, the reference FC-SCED-104S corresponds to a piloted flange housing with insert bearing for a specific shaft size. When ordering via WhatsApp, send the complete code so we can quote the exact variant.

In Argentine industry these units appear in food, cement, paper, water treatment and material handling plants. They are also found in milling equipment, fans, bucket elevators and machine tools, where the flange housing allows mounting the shaft against a flat face and maintaining alignment without the need for a special base. It is a common solution when the shaft runs horizontally and the flange is bolted to a panel or frame.

To choose the right housing, take into account the shaft diameter and tolerance, the insert locking type (set screw or eccentric), the sealing required by the environment and the intended lubrication. Installation requires placing the flange on a clean, flat surface, tightening the bolts in a cross pattern and verifying that the shaft turns without effort. If the equipment operates with dust, water or frequent washdowns, it is advisable to check the insert sealing before start-up.

Among brands, piloted flange housings with insert are interchangeable by shaft number and housing type, but the mounting hole diameters and pilot height do not always match. Therefore, before replacing a unit, compare the flange, the pilot diameter and the insert locking system. At MR Accesorios Industriales we indicate the alternative compatible with the code you provide.

If you need this housing or a variant of the SCED series, send the code or model via WhatsApp to MR Accesorios Industriales. We will quote you shortly and help you define the option that best suits your equipment, whether it is a direct replacement or an adaptation with the same performance.