DODGE FBSO-SCFS-30M-SHFS flange bearing 4 holes

DODGE FBSO-SCFS-30M-SHFS is a reference of flange bearing 4 holes, within Bearing housings. Request a quote for FBSO-SCFS-30M-SHFS via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DODGE SCFS series 4-bolt flange Y-bearing unit is a mounted assembly that combines a cast iron housing with a self-aligning insert bearing. It is used to support rotating shafts on flat structures, where the flange is bolted down and the insert absorbs minor misalignment. It is a compact, robust solution for power transmission in industrial equipment.

The SCFS series designation is read in blocks: the letters identify the housing type and flange configuration, while the number that follows indicates the shaft diameter in millimeters. In the examples FBSO-SCFS-20M-SHFS, FBSO-SCFS-25M-SHFS, FBSO-SCFS-30M-SHFS and FBSO-SCFS-35M-SHFS, the numeric value corresponds to the shaft size indicated in each part number. The M and SHFS suffixes refer to sealing and insert locking variants. To correctly interpret each part number, it is best to follow the complete series scheme.

These units are used in conveyors, mixers, fans, pumps and agricultural machinery, where a shaft must be mounted on a flat surface with four anchoring points. In Argentina, they are common in food plants, cement plants, tanneries and process equipment in general. The 4-bolt flange allows stable fastening and distributes loads better than a conventional pillow block.

To select the correct unit, take into account the shaft diameter, the type of load (radial, axial or combined) and the environmental conditions. The insert seal defines the protection against dust and moisture: choose higher-containment seals in dirty environments or where frequent washdowns occur. Lubrication must be the one specified by the manufacturer, and installation requires aligning the flange with the mounting surface to avoid parasitic stresses. The self-alignment of the insert compensates for small deviations, but it does not replace proper leveling.

As for equivalents, 4-bolt flange units with insert bearings from other brands can be interchanged if the flange dimensions, shaft diameter and insert locking type match. A similar part number is not enough: the mounting drawings must be verified. MR Accesorios Industriales sells the DODGE brand and can advise you on compatibility with other alternatives on the market.

If you need to replace a flange Y-bearing unit or look for an alternative for your equipment, send the part number or shaft dimensions by WhatsApp to MR Accesorios Industriales. We will quote you promptly and indicate the option that best suits your application.