DODGE FBSO-SCFS-008L-SHFS flange bearing 4 holes

DODGE FBSO-SCFS-008L-SHFS is a reference of flange bearing 4 holes, within Bearing housings. Request a quote for FBSO-SCFS-008L-SHFS via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DODGE SCFS series 4-bolt flange bracket with insert bearing is a square flange mounted bearing that fastens to the structure with four bolts, with the shaft passing through the center. It is used to support transmission shafts in equipment where rigid, centered mounting is required, and it allows the assembly to be aligned with the shaft line before tightening. MR Accesorios Industriales sells it in Buenos Aires, Argentina.

The SCFS series designation is read in blocks: the letters identify the type of bracket and its flange configuration, and the three-digit number that follows indicates the nominal shaft diameter in inches, expressed in thousandths. The final letter L corresponds to the insert locking variant on the shaft, and the SHFS suffix defines the sealing and housing characteristics. That is why the codes in the SCFS series are the same bracket for different shaft sizes: the diameter changes, not the flange geometry.

In Argentine industry these brackets appear in belt and roller conveyors, mixers, screens, fans, centrifugal pumps and packaging lines. They are also found in milling equipment, aggregate processing plants and material handling systems where the shaft works with moderate radial load and the flange allows mounting on sheet metal or profile structures. Being a mounted bearing, it simplifies assembly: there is no need to machine a housing, only a flat surface with the four holes.

To select the bracket, start with the shaft diameter and the type of load: the 4-bolt flange gives more stable mounting than a pillow block when there is vibration or forces in several directions. Check the insert sealing according to the environment: dust, water or frequent washing require tighter protection. During assembly, rest the flange on a clean, flat surface, present the bolts without tightening, align the shaft with the transmission line and only then tighten in a cross pattern. Lubricate the insert according to the duty cycle and check the radial clearance before starting up.

Flange mounted bearings are available from several brands with their own nomenclatures, and shaft sizes and mounting holes usually match between equivalent lines. Interchangeability does not depend only on diameter: compare the distance between holes, the flange diameter, the shaft center height and the type of insert locking. It can be replaced by a reference with equivalent performance while maintaining those dimensions. MR Accesorios Industriales sells DODGE and will indicate the compatible alternative.

If you need the SCFS flange bracket for a particular piece of equipment, send the full code, the shaft diameter or a photo of the equipment nameplate via WhatsApp. With that data we will quote the reference and, if applicable, indicate the compatible alternative. MR Accesorios Industriales responds promptly.