DODGE FB-DLEZ-20M-P flange bearing 4 holes

DODGE FB-DLEZ-20M-P is a reference of flange bearing 4 holes, within Bearing housings. Request a quote for FB-DLEZ-20M-P via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DODGE 4-bolt flange housing with insert bearing is a mounted unit that combines a cast iron housing with an insert ball bearing. It is fastened to a flat surface with four bolts and allows mounting drive shafts with simple alignment. It is used in equipment where radial loads and some axial thrust must be supported, with the advantage of quick mounting and simple maintenance. MR Accesorios Industriales sells this line in Buenos Aires, Argentina.

The designation FB-DLEZ corresponds to a 4-bolt flange housing of the ER-Series. The letters FB indicate flange (flange bracket), DL refers to the insert type with set screw locking, EZ identifies the insert bearing series, and the final M indicates the presence of a grease groove or a specific lubrication configuration. The number appearing between DLEZ and M (for example, 20, 25, 30 or 35) indicates the nominal shaft diameter in millimeters. The final P may refer to a sealing variant or a particular design feature. Thus, FB-DLEZ-20M-P is a housing for a 20 mm shaft, and FB-DLEZ-35M-P for a 35 mm shaft.

These housings are used in a wide variety of industrial applications in Argentina: belt conveyors, bucket elevators, mixers, fans, centrifugal pumps, machines for the food industry and agricultural equipment. Their flange design allows mounting on walls or flat structures, with the shaft perpendicular to the mounting surface. They are common in food and beverage plants, aggregate processing plants, sugar mills and poultry facilities, where ease of cleaning and efficient sealing are important.

To select the right housing, take into account the shaft diameter, the radial and axial loads it must support, and the environmental conditions. The insert seal protects against dust and moisture; in environments with a lot of dirt or frequent washdowns, it is advisable to check the seal type. Mounting requires the mounting surface to be flat and clean, and the four bolts to be tightened evenly to avoid deformation. Lubrication must be the one specified by the manufacturer, and it is important to check shaft alignment so as not to overload the bearing. The insert's internal clearance is already set at the factory.

As for equivalents, 4-bolt flange housings with insert bearing from different brands can be interchanged if the flange dimensions, shaft diameter and insert locking type match. However, not all part numbers are equivalent to each other: differences in sealing, locking system or load capacity may make a direct replacement unsuitable. Therefore, it is always advisable to compare the critical dimensions and consult a specialist before replacing a unit.

If you need a DODGE flange housing, write to us via WhatsApp with the part number or the equipment dimensions. At MR Accesorios Industriales we will quote you shortly and advise you so you find the right part. We can also evaluate in-house manufacturing of special housings if the mounting requires it.