DODGE F4B-SXR-60M-FF flange bearing 4 holes

DODGE F4B-SXR-60M-FF is a reference of flange bearing 4 holes, within Bearing housings. Request a quote for F4B-SXR-60M-FF via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

DODGE F4B-SXR series 4-bolt flange mounted bearings are units that combine a bearing and its housing in a single assembly. This type includes part numbers such as F4B-SXR-17M-FF, F4B-SXR-45M-FF and F4B-SXR-75M-FF. The -FF suffix is part of the part number and identifies this version.

The four-bolt flange is bolted against a flat surface perpendicular to the shaft, such as a machine face, a frame or a closing plate. The four mounting points distribute the load and give the unit stable support. A mounted unit arrives as an assembly, which simplifies installation and replacement compared with assembling the bearing and housing separately.

Part numbers of this type follow the format F4B-SXR, a number followed by the letter M (17M, 30M, 55M, 60M, 75M, among others) and the -FF suffix. The number identifies the shaft size and changes with each unit. The -FF suffix distinguishes this version from the one ending in M: if you omit it, you are ordering a different unit.

When choosing a unit of this type, check the shaft diameter, the mounting surface and the environment where it will operate. A worn or out-of-tolerance shaft affects any bearing, so it is best to measure it before installing the replacement.

For mounting, make sure the mounting surface is flat and the shaft is aligned with the unit. Tighten the bolts in a crosswise, even pattern, then turn the shaft by hand to confirm there are no hard spots. Any question about shaft mounting is answered by the manufacturer's data sheet.

To request a quote, send us the full part number by WhatsApp or email, such as F4B-SXR-45M-FF, along with the quantity you need. A photo of the installed unit helps confirm it. We reply promptly, from Buenos Aires, Argentina.