DODGE F4B-SXR-112 flange bearing 4 holes

DODGE F4B-SXR-112 is a reference of flange bearing 4 holes, within Bearing housings. Request a quote for F4B-SXR-112 via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DODGE SXR series 4-bolt flange Y-bearing unit is a mounted assembly that combines a cast iron housing with an insert ball bearing, ready to be bolted to a flat surface. It is used to support rotating shafts in power transmission equipment, where rigid support and simple alignment are required. MR Accesorios Industriales sells this DODGE line in Buenos Aires, Argentina, with technical advice to choose the right size.

The SXR series designation is read in blocks: the letter F indicates the housing type, the number that follows identifies the size and the mounting variant, and the SXR suffix defines the insert bearing series. In the examples, the last numeric group changes according to the shaft diameter and the insert type. To correctly interpret each code, it is best to consult the DODGE interchange table or send us the full code by WhatsApp.

These units are used in belt conveyors, mixers, mills, centrifugal pumps, fans and packaging lines. In the Argentine market they are common in food, cement, chemical and aggregate processing plants, where the 4-bolt flange mounting makes installation on steel structures or masonry easier. The SXR series handles radial loads and some axial thrust, and its design allows the insert to be replaced without disassembling the entire housing.

To select the unit, take into account the shaft diameter, the radial and axial load, and the environmental conditions. The insert sealing —with lip seals or labyrinth type— defines the protection against dust, water or chips. Internal clearance and lubrication must be suitable for the rotation speed. During mounting, check the flange alignment and the even tightening of the four bolts to avoid deformation and premature failure.

DODGE SXR series units are interchangeable with other 4-bolt flange mounted brands that follow the same standardized dimensions. When replacing, compare the shaft diameter, the bolt hole spacing, the flange diameter and the insert type. We can indicate the compatible alternative. MR Accesorios Industriales sells DODGE and advises you so the replacement is direct.

If you need a flange Y-bearing unit for your equipment, send us the full code —for example F4B-SXR-010— or the shaft and flange dimensions by WhatsApp. We will quote you shortly and indicate the option that best suits your application. We can also evaluate variants within the DODGE line for specific load, speed or environment conditions.