Flange bearing 4 holes DODGE F4B-SCEZ-104S-P

DODGE F4B-SCEZ-104S-P is a flange bearing 4 holes reference, within Bearing housings. Request a quote for F4B-SCEZ-104S-P via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The SCEZ series 4-bolt flange housing with insert bearing is a mounted unit that combines a cast iron housing with an insert ball bearing, ready to be fastened to a flat surface with four bolts. It is used to support shafts in equipment where the load is mainly radial and simple alignment and quick mounting are required. MR Accesorios Industriales carries this DODGE line in Buenos Aires, Argentina.

The SCEZ series designation is read in blocks: the letter F indicates the flange housing type, the number that follows defines the size of the insert bearing and the letters SCEZ identify the construction series. The suffix S-P appears at the end of the part number and distinguishes the sealing and locking variant of the insert. A specific example is F4B-SCEZ-104S-P: there you can see the complete order, with the shaft size in the numeric block and the insert configuration in the final segment.

These housings are seen in belt conveyors, packaging lines, mixers, blowers and process lines in food, chemical and aggregates plants. In Argentina they are common in material handling equipment and in machines that work with low and medium speed transmission shafts. The 4-bolt flange allows them to be mounted on sheet metal or profile structures, with the mounting surface machined so that the insert does not work under strain.

To choose correctly, take into account the shaft diameter, the type of load and the environmental conditions. The insert sealing defines whether the housing withstands dust, water or frequent washdowns; in humid environments a variant with an additional seal is advisable. When mounting, place the flange on a clean, flat surface, tighten the four bolts in a cross pattern and verify that the shaft rotates without axial clearance. The insert lubrication is replenished according to the duty cycle and the type of seal.

Flange housings with insert bearings are interchangeable between manufacturers when the flange dimensions, the shaft diameter and the insert locking system match. It is not enough for the part number to be similar: you must compare the hole spacing, the outer ring diameter and the locking type. If you need to replace an existing unit, send the part number or a photo of the part by WhatsApp to MR Accesorios Industriales and we will indicate the compatible alternative.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.