Flange bearing 4 holes DODGE F4B-GTMAH-103

DODGE F4B-GTMAH-103 is a flange bearing 4 holes reference, within Bearing housings. Request a quote for F4B-GTMAH-103 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DODGE GTMAH series flanged Y-bearing unit is a 4-bolt flanged mounted bearing: the unit combines a ball insert with a flange housing that is fastened to the frame with four bolts. It is used to support rotating shafts in equipment where the load is mainly radial and the mounting must sit flat against a surface. MR Accesorios Industriales supplies it in Buenos Aires, Argentina.

The GTMAH series designation is read in blocks: the leading letter F indicates the flange format, the number that follows defines the housing size and the final numeric suffix identifies the shaft diameter. In the examples F4B-GTMAH-012, F4B-GTMAH-100 and F4B-GTMAH-115, the last segment changes according to the shaft each unit is intended for. The GTMAH block identifies the family of 4-bolt flange housing with ball insert. To select, send us the complete part number and the shaft diameter.

These housings appear in belt conveyors, sorting belts, mixers, dryers, blowers and packaging lines. In agriculture they are seen in seeders, extractors and grain storage equipment; in food and beverage plants, on drive shafts and process rollers. The 4-bolt flange allows them to be fastened to sheet metal or profile structures, with the shaft perpendicular to the mounting plane. In plants in Buenos Aires and the interior they are widely used to replace worn units without modifying the existing structure.

To select the unit, start from the shaft diameter and the type of load: if there is axial load, evaluate a housing with greater capacity or a two-bearing arrangement. Check the insert sealing according to the environment: dust, water or frequent washdown require tighter protection. During mounting, rest the flange on a flat, clean surface, tighten the four bolts in a cross pattern and verify shaft alignment before applying the final torque. Lubricate according to the duty cycle and check the insert clearance.

Flanged mounted units are interchanged between brands by shaft number and by flange dimensions: bolt circle diameter, number of bolts and housing height. It is not enough for the shaft diameter to match. If the original part number is not available, it can be replaced by a unit with equivalent performance from another line, always comparing those dimensions and the type of sealing. Send us the measurements or the drawing and we will indicate the compatible alternative.

If you need the GTMAH series flanged Y-bearing unit for a running piece of equipment, write to us on WhatsApp with the complete part number or with the shaft diameter and the flange measurements. At MR Accesorios Industriales we will quote the reference and, if necessary, indicate the compatible alternative so that the mounting can continue without stopping the line.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.