DODGE F4B-GT-09 flange bearing 4 holes

DODGE F4B-GT-09 is a reference of flange bearing 4 holes, within Bearing housings. Request a quote for F4B-GT-09 via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DODGE GT series 4-bolt flange Y-bearing unit with insert bearing is a mounted 4-bolt flange bearing designed to secure rotating shafts to a flat structure and support moderate radial and axial loads. It is used in equipment where the shaft needs firm support and simple alignment, with the advantage of bolted mounting and an insert that rotates within the outer race. MR Accesorios Industriales sells this line in Buenos Aires, Argentina.

The designation of the GT series is read in blocks: the letter F indicates the flange housing type, the number that follows defines the housing size and the GT suffix identifies the Grip Tight family, with its system for securing the insert to the shaft. Thus, references such as F4B-GT-03, F4B-GT-04 or F4B-GT-08 share the same logic: the size of the housing and insert bearing changes, not the mounting principle. In three-digit codes, such as F4B-GT-008, the leading zero orders the size within the series.

These housings appear in belt conveyors, packaging lines, mixers, blowers, centrifugal pumps, screens and milling lines. In the Argentine market they are found in food plants, meat processing plants, cement plants, tanneries and metalworking shops, where the drive shaft works with dust, humidity or frequent washdowns. The 4-bolt flange allows anchoring onto sheet metal or profile structures, and the insert absorbs small misalignments without requiring complex machining.

To choose well, first define the shaft diameter and the load the support will bear; then check the sealing, because a simple contact seal does not perform the same as one with an additional lip in environments with water or particles. Mounting requires placing the flange on a clean, flat surface, tightening the bolts in a cross pattern and verifying that the shaft is aligned with the adjacent support. Insert lubrication is replenished according to the duty cycle, and it is advisable to turn the shaft by hand before starting the equipment.

Regarding equivalences, 4-bolt flange housings with insert bearings are interchanged between manufacturers by shaft size, bolt hole spacing and center height, not by commercial code. Therefore, if you need to replace a DODGE GT series unit, send us the old code and the shaft and housing dimensions: we will indicate the compatible alternative. We can also evaluate sealing or locking variants according to the working environment.

If you have the housing code at hand, send it via WhatsApp to MR Accesorios Industriales along with the shaft diameter and a photo of the mounting. With that data we will quote the corresponding DODGE GT series reference and, if necessary, propose the equivalent option so the equipment gets running again without delay.