DODGE F4B-DLM-35M flange bearing 4 holes

DODGE F4B-DLM-35M is a reference of flange bearing 4 holes, within Bearing housings. Request a quote for F4B-DLM-35M via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The 4-bolt flange bearing housing with DODGE D-Lok series insert bearing is a mounted assembly that combines a cast iron housing with a ball insert bearing, ready to be fastened to a flat surface with four screws. It is used to support rotating shafts in equipment that requires rigid fastening and simple alignment, such as belt conveyors, mixers, fans and process machinery. MR Accesorios Industriales sells this line.

The D-Lok series designation is read in blocks: the initial letters indicate the housing type and the number of mounting holes, the middle block identifies the insert bearing series and the final number corresponds to the shaft diameter in millimeters. For example, the codes in the series are 4-bolt flange housings for shafts of different diameters. The M ending indicates the metric system. Knowing this structure allows you to order the exact code.

In Argentine industry, these housings appear in belt conveyors, bucket elevators, mills, balanced feed mixers, water treatment plants and refrigeration equipment. The 4-bolt flange allows the assembly to be mounted on sheet metal structures or profiles, with the possibility of adjusting the shaft position before tightening the screws. It is a common solution when a robust support that is easy to replace during maintenance is needed.

To select the housing, take into account the shaft diameter, the type of load (radial, axial or combined) and the environmental conditions. The insert seal protects against dust and humidity; in environments with frequent washdown or fine particles, it is advisable to check the seal type. Mounting requires a flat, clean surface, screws tightened in a cross pattern and careful alignment to avoid stresses on the bearing. Proper lubrication and correct internal clearance extend the service life of the assembly.

Insert bearing housings from different brands are often interchangeable if the flange dimensions, shaft diameter and locking system match. When requesting a quote, compare the main dimensions and the insert type: it is not enough for the code to be similar. MR Accesorios Industriales advises you to find the right equivalence within its line of housings and bearings, without compromising equipment performance.

If you already have the code of the housing you need, send it by WhatsApp to MR Accesorios Industriales and we will quote it promptly. If you are looking for a variant you do not see, write to us with the model or shaft dimensions and we will indicate the compatible alternative. We can also review the complete assembly to suggest the insert and housing that best suit your application.