DODGE F2B-VSC-200L-NL flange bearing 2 holes

DODGE F2B-VSC-200L-NL is a reference of flange bearing 2 holes, within Bearing housings. Request a quote for F2B-VSC-200L-NL via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The 2-bolt flange unit with DODGE VSC series insert bearing is a mounted assembly that combines a cast iron housing with an insert ball bearing, ready to be fixed onto a flat surface. It is used to guide and support rotating shafts in equipment where the mounting must be face-supported, with two anchoring points that absorb torque and maintain shaft alignment.

The designation of these units is read in blocks. In F2B-VSC-200L-NL, the first part indicates the 2-bolt flange configuration; VSC identifies the unit and insert series; the number that follows corresponds to the nominal shaft diameter; and the final suffixes indicate sealing, locking or finish variants. Therefore, two units of the same series may differ in the type of seal or in the insert locking system on the shaft.

In Argentine industry they appear in belt and roller conveyors, packaging lines, mixers, fans, centrifugal pumps and milling equipment. They are also found in food, water treatment, cement and mining plants, where the flange unit allows mounting the shaft on steel structures or partitions without machining a complete housing. The cast iron housing and sealed insert tolerate dust, moisture and frequent washdowns.

To choose correctly, take into account the shaft diameter, the insert locking type and the sealing required according to the environment. During mounting, rest the flange on a clean, flat surface, tighten the bolts in a cross pattern and verify shaft alignment before start-up. The insert is lubricated from the factory; in service, follow the plant's greasing plan and avoid impacts on the housing.

Insert bearing units are interchangeable between manufacturers by series, shaft diameter and flange configuration, but the locking system, center height and sealing change. Therefore, it is advisable to compare the full designation and not just the diameter. If you need to replace an existing assembly, send the part number or model by WhatsApp to MR Accesorios Industriales and we will indicate the compatible alternative.

MR Accesorios Industriales supplies the DODGE brand and manufactures split plummer block housings, ANSI chains and pulleys in Buenos Aires, Argentina. The technical team advises on selection, mounting and replacement of insert bearing units and bearings. Send your inquiry by WhatsApp with the part number F2B-VSC-200L-NL or the one shown on your equipment and we will respond promptly.