DODGE F2B-SCED-008L flange bearing 2 holes

DODGE F2B-SCED-008L is a reference of flange bearing 2 holes, within Bearing housings. Request a quote for F2B-SCED-008L via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DODGE SCED 2-bolt flange bearing with insert bearing is a mounted assembly that combines a cast housing with an insert ball bearing, ready to be fastened to a flat surface with two bolts. It is used to guide rotating shafts in equipment where simple and rigid fastening is required, with initial alignment already resolved by the mounting. MR Accesorios Industriales supplies this DODGE line in Buenos Aires, Argentina.

The SCED series designation is read in blocks: F indicates the 2-bolt flange, B the housing type, and SCED the insert bearing series with its sealing and locking characteristics. The final number — as in F2B-SCED-008L, F2B-SCED-010L or F2B-SCED-110L — identifies the shaft diameter size. The final letter L indicates a locking or sealing variant within the same family. To order the correct part number, provide the complete designation as it appears on the drawing or on the equipment nameplate.

These flange bearings appear in belt conveyors, bucket elevators, mixers, blowers, centrifugal pumps and packaging lines. In Argentina they are seen in food plants, cement plants, tanneries, water treatment plants and metalworking shops. The 2-bolt flange allows them to be mounted on walls or structures with limited space, and the insert bearing absorbs slight misalignments from assembly. It is a common solution when the shaft cannot be supported on a pillow block.

To select the flange bearing, start from the shaft diameter you need and the mounting type: 2-bolt flange with center distance compatible with your structure. Check the insert seal: SCED units come with seals that protect against dust and moisture, suitable for environments with moderate dirt. During mounting, place the flange on a clean, flat surface, tighten the bolts in a cross pattern and verify that the shaft turns without effort. The insert is lubricated from the factory; in service, replenish grease according to the operating regime.

If you need to replace an existing flange bearing, compare the complete designation and the flange dimensions: distance between holes, shaft diameter and locking type. Series from other brands with equivalent mounting may be interchangeable, but always verify the housing dimensions and the insert fastening system before ordering. At MR Accesorios Industriales we will indicate the compatible alternative if you send us the original part number or the assembly measurements.

To request a quote for your DODGE SCED flange bearing, send the complete part number via WhatsApp — for example F2B-SCED-008L — or the shaft and flange measurements. We will reply shortly with the corresponding reference. If you are looking for a variant that does not appear in the list, write to us with the model you need and we will quote it.