Flange bearing 2 holes DODGE F2B-GTAH-104S

DODGE F2B-GTAH-104S is a flange bearing 2 holes reference, within Bearing housings. Request a quote for F2B-GTAH-104S via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DODGE GTAH Y-bearing insert unit is a two-bolt flange mounted unit that combines a ball insert bearing with a cast iron housing. It is used to support rotating shafts in equipment where simple, robust mounting is required, with self-alignment and built-in lubrication. It is a common solution in belt drives, conveyor belts and agricultural machinery, among other applications.

The GTAH series designation is read in blocks: the letter F indicates the flange type, the number that follows defines the nominal shaft diameter, and the suffix GTAH identifies the housing and insert series. For example, F2B-GTAH-104S corresponds to a two-bolt flange unit for a 1 1/4 inch shaft, with a GTAH series insert. The final suffix S indicates a seal variant. Knowing this structure lets you request the full part number and avoid confusion when replacing an existing unit.

In Argentine industry, these units appear in belt conveyors, mixers, fans, centrifugal pumps and process equipment. They are also found in agriculture, in seeders, harvesters and grain elevators, where the dusty environment demands effective sealing. The cast iron housing and the ball insert absorb minor misalignments and combined loads, which simplifies mounting and reduces maintenance in plants that operate continuously.

To select the correct unit, take into account the shaft diameter, the load type and the environmental conditions. The GTAH series allows self-alignment, which compensates for small mounting errors. Check that the seal is suitable for dust or moisture, and that the lubrication is the one specified by the manufacturer. During mounting, make sure the flange sits properly on the surface and that the bolts are tightened evenly to avoid deformation.

Mounted units from different brands can be interchanged if the flange dimensions, shaft diameter and mounting type match. In general, GTAH series part numbers correspond to other two-bolt flange unit lines, but it is advisable to verify the hole dimensions and the center height. MR Accesorios Industriales supplies the DODGE brand and can guide you to find the right equivalent.

If you need to replace a Y-bearing insert unit, send the full part number on WhatsApp to MR Accesorios Industriales. With the model or the shaft and flange dimensions, we will quote the DODGE GTAH series unit or the compatible alternative that best suits your equipment. We can also advise you on mounting and lubrication to extend the service life of the assembly.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.