Flange bearing 2 holes DODGE 124640

DODGE 124640 is a flange bearing 2 holes reference, within Bearing housings. Request a quote for 124640 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DODGE Y-bearing housing with insert is a two-bolt flange mounted unit that combines an insert ball bearing with a cast iron housing. It is used to support rotating shafts in equipment where a compact, self-aligning and easy-to-mount unit is required. MR Accesorios Industriales supplies this DODGE line in Buenos Aires, Argentina, with more than 80 years of experience in power transmission and bearings.

The DODGE LF series is identified by its two-bolt flange housing and the insert bearing it houses. The series part numbers, such as 050895, 065699 or 124600, refer to specific configurations of shaft diameter, locking type and sealing. The LFT variant corresponds to a particular design within the same family. To choose the correct part number, have the shaft diameter, mounting type and operating conditions at hand; with that data we will indicate the exact reference.

These housings are used in conveyors, belts, elevators, mixers, fans and process lines in the food, chemical, cement and aggregate industries. In Argentina they are common in milling plants, water treatment plants and material handling equipment. Their two-bolt flange allows them to be fastened to metal structures or masonry with simple alignment, and the insert accommodates minor misalignments typical of long shafts or chassis-mounted assemblies.

To select the housing, check the shaft diameter and the insert locking type: they are available with set screws, eccentric collar or taper sleeve. Sealing can be single contact or with an additional radial shaft seal for dusty or humid environments. Factory lubrication is usually sufficient for the service life, but in severe applications relubrication should be considered. When mounting, align the flange and tighten the bolts evenly to avoid deforming the housing; poor alignment accelerates insert wear.

DODGE mounted units are interchangeable with other brands of two-bolt flange Y-bearing housings, provided the flange dimensions, shaft diameter and locking type match. A similar part number is not enough: the mounting drawing must be compared. If you need to replace an existing unit, send us the original part number or the flange and shaft measurements, and we will indicate the compatible alternative from our catalogue.

MR Accesorios Industriales supplies the DODGE line in Buenos Aires, Argentina, and manufactures split plummer block housings, ANSI roller chains and pulleys (sheaves). If you are looking for a Y-bearing housing with insert for your equipment, write to us on WhatsApp with the part number or model you need: we will quote it shortly and advise you so that the unit is properly mounted.

This description provides guidance on the product type. Check the configuration and dimensions of this reference.