DBH 9795 radial shaft seal — 32 x 43 x 12.5

DBH 9795 is a reference of radial shaft seal, within Seals. Request a quote for 9795 via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DBH 9795 radial shaft seal is a lip seal that mounts in cylindrical housings to retain lubricant and exclude contaminants in rotating equipment. Its dimensions of 32.00 mm shaft, 43.00 mm housing and 12.50 mm height place it in the range of compact general-purpose seals. It is a wear part: when the lip hardens or becomes marked, oil loss appears and it should be replaced before it damages the bearing or the bushing.

This item is a DBH 9795 radial shaft seal, identified by its designation 9795. Its published attributes are: shaft diameter 32 mm, housing diameter 43 mm, height 12.50 mm and design Lx. The Lx design corresponds to a single-lip seal with spring, intended for rotating shafts with lubrication. DBH is a brand that MR carries, so the part number is ordered exactly as it appears on the equipment data sheet or on the old seal.

Typical applications for a seal of these dimensions are small gearboxes, centrifugal pumps, electric motors, transmission shafts and process equipment with 32 mm shafts. In all cases it performs two functions: retaining the oil or grease inside the housing and blocking the entry of dust, wash water or chips. It is commonly found at a gearbox output or at the end of a shaft that rotates on a single-row deep groove ball bearing.

Before mounting, check that the shaft has no burrs or wear in the contact area and that the housing is clean and free of dents. Lubricate the lip with the same grease or oil used in the equipment before inserting it, and apply force on the outer ring, never on the lip. If the shaft shows a deep groove, a new seal may not seal: in that case it is worth evaluating a wear sleeve or a different shaft size. Selection is defined by the three dimensions and by the type of design.

To quote part number 9795, send us the shaft, housing and height dimensions, plus a photo of the seal and the housing. With that we look for the equivalent in DBH or another brand that MR carries, respecting the Lx design or whichever applies. We also tell you whether the original seal was replaced by a version with a dust lip or with a double lip, depending on the contamination level of the equipment.

To request a quote for the DBH 9795 oil seal, write to us on WhatsApp with part number 9795 or with the dimensions 32 x 43 x 12.50 mm. MR Accesorios Industriales carries seals and oil seals together with bearings, bushings and power transmission, so if the seal is mounted on a bearing, we can review the complete assembly. The quote is prepared with the exact part number and the quantity you need.