Radial shaft seal DBH 9626 — 100.00 x 125.00 x 15.00

DBH 9626 is a radial shaft seal reference, within Seals. Request a quote for 9626 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DBH 9626 seal is a radial seal with a 100 mm shaft diameter, 125 mm housing diameter and 15 mm height. It is used to retain lubricant and exclude dust and water in rotating equipment, with the shaft turning and the housing fixed. It is a wear part: when oil loss, contaminant ingress or bearing noise appears, it should be replaced. MR Accesorios Industriales supplies this brand and helps you identify the correct size.

The DBH 9626 is a radial shaft seal with the following dimensions: shaft diameter 100 mm, housing diameter 125 mm and height 15.00 mm. The stated design is Lr, which corresponds to a single sealing lip with spring. These are the dimensions you must verify before ordering: the shaft diameter where the lip rests, the housing diameter where it is press fitted and the available width. If any of them does not match, the seal will not seal properly.

It is used in gearboxes, centrifugal pumps, electric motors, rollers and power transmission equipment where there is a rotating shaft coming out of a lubricated sump. It also appears in applications exposed to dust, wash water or chips, where the seal serves a dual purpose: it retains the oil inside and blocks the ingress of contaminants from outside. It is commonly found mounted on deep groove ball bearings or tapered roller bearings in continuous process equipment.

To select it properly, in addition to the dimensions, take into account the shaft speed, the working temperature and the type of lubricant. A lip with spring such as the Lr design works best with medium-hardness, polished shafts; if the shaft is scratched or worn, the new seal may not seal. When installing it, lubricate the lip, check that the spring does not come out and tap the seal with a tube or shim that presses on the outer edge, never on the lip.

If the 9626 is not the size you need, or if the housing has a different tolerance, we can look for a nearby size or an equivalent within the same radial shaft seal category. To do that, send us the old part number, the dimensions taken with a caliper or a photo of the part and the housing. The more data you give us, the faster we can confirm the alternative.

To request a quote for the DBH 9626 seal or ask about an equivalent size, write to us on WhatsApp at MR Accesorios Industriales with part number 9626 and the dimensions. We reply with the alternative that best fits your equipment.