Radial shaft seal DBH 9562 — 35.00 x 48.00 x 12.50

DBH 9562 is a radial shaft seal reference, within Seals. Request a quote for 9562 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DBH 9562 radial shaft seal is a lip seal that closes off the passage of oil or grease between a rotating shaft and its housing. It is used in gearboxes, pumps, electric motors and transmission equipment to prevent leaks and the entry of dust or water. Its designation indicates the dimensions: 35 mm shaft, 48 mm housing and 12.50 mm height, with Lx design. It is a wear part that should be replaced when lubricant loss or lip play appears.

This item is a DBH 9562 radial shaft seal, identified by its part number 9562. The dimensions listed on the product page are 35 mm shaft diameter (d), 48 mm housing diameter (D) and 12.50 mm height (h). The design is Lx, which defines the configuration of the lip and the metal body. With these three values you can verify compatibility with the housing and the shaft before installing it. If your equipment requires another size, the equivalent can be found in the same DBH line.

Typical applications for a seal of this size are input and output shafts of gearboxes, centrifugal pumps, electric motors, mixers and belt or chain transmission equipment. In all these cases the seal runs on a rotating shaft and separates the lubricant from the environment. It is also used in agricultural machinery and in process equipment where there is dust or water. The choice of lip material and spring depends on the temperature and the fluid, data confirmed with the manufacturer's product page.

To install a radial shaft seal, it is advisable to check the condition of the shaft: it must not have burrs or wear in the contact area. The housing must be clean and free of dents. It is recommended to lubricate the lip before inserting it and to use an installation tube that presses on the outer edge, never on the lip. If the shaft shows a deep mark, the new seal may lose its sealing ability quickly. At MR Accesorios Industriales we can guide you on installation and on the right design for your equipment.

If you need an equivalent or a neighboring size, send us part number 9562 or the dimensions 35 x 48 x 12.50 mm by WhatsApp. It also helps to send a photo of the old seal and the housing, or the equipment drawing. With that data we search the DBH line and other alternatives we carry. If the Lx design is not the right one, another type of lip or material can be evaluated. The idea is for you to receive the correct part without hassle.

MR Accesorios Industriales carries the DBH brand as part of its line of seals and oil seals. If you have doubts about the size or design, write to us by WhatsApp with part number 9562 and we'll quote you. We can also advise you if you need to replace a seal that no longer has a visible identification.