DBH 9363 radial shaft seal — 30 x 58 x 8

DBH 9363 is a reference of radial shaft seal, within Seals. Request a quote for 9363 via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DBH 9363 radial oil seal is a lip seal that closes off lubricant and blocks dust, water or particles from entering equipment with a rotating shaft. Its Lx design and dimensions of 30 mm shaft, 58 mm housing and 8 mm height make it suitable for gearboxes, pumps, electric motors and transmissions that work with oil or grease. MR Accesorios Industriales sells this brand and helps you confirm the size before quoting.

This item is a radial oil seal from the DBH line, identified with the code 9363. It runs on a shaft of 30 mm diameter, fits into a 58 mm bore and has a total height of 8.00 mm. The Lx design corresponds to a single-lip oil seal with spring, intended for rotating shafts with internal lubrication. The manufacturer's nomenclature is read directly on the product and allows the same seal to be ordered without ambiguity.

It is used in equipment where oil or grease must be retained and, at the same time, dirt must be prevented from entering from the outside. It is commonly found in gearboxes, centrifugal pumps, electric motors, conveyor rollers, mixers and belt or chain transmissions. It is also replaced in old machines where the original size is no longer available as an assembly and the loose oil seal is sought by its dimensions.

To install it, check that the shaft has no burrs or wear and that the housing is clean and free of dents. Lubricate the lip with the same grease or oil as the equipment before inserting it, and apply force on the outer ring, never on the lip. If the shaft shows a deep groove, consider an oil seal with the lip in another position. Selection depends on speed, temperature and type of fluid, data that should be at hand.

If you need an equivalent, send us the shaft diameter, housing diameter and height you measured, plus a photo of the old oil seal if possible. With that data we review alternatives within the same DBH line or other brands we carry. We can also advise you if the housing is damaged and a repair sleeve or an oil seal with reinforced case needs to be considered.

To request a quote for the DBH 9363 oil seal, send the code on WhatsApp to MR Accesorios Industriales along with the quantity you need. If you have doubts about the size, write to us anyway: we help you confirm it against the manufacturer's data sheet before proceeding. We handle technical inquiries for bearings, seals, transmission and bearing housings so that you order once and receive the right part.