Radial shaft seal DBH 8954 — 62.00 x 90.00 x 10.00

DBH 8954 is a radial shaft seal reference, within Seals. Request a quote for 8954 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DBH 8954 radial shaft seal is a lip seal that mounts in the housing and seals against the rotating shaft to retain lubricant and block the entry of dust, water or particles. Its Lx design and dimensions of 62 mm shaft, 90 mm housing and 10 mm height make it suitable for gearboxes, pumps, electric motors and power transmission equipment. MR Accesorios Industriales offers it as part of its seals and oil seals line.

This item is a radial shaft seal from the DBH brand, identified by code 8954. Its nominal dimensions are 62 mm shaft diameter (d), 90 mm housing diameter (D) and 10 mm height (h). The Lx design corresponds to the lip and case configuration according to the manufacturer's designation. It is a standard-section seal for rotating shafts, with a sealing lip that runs on the shaft surface and an outer case that fits into the housing. Tolerances and loads are not published because they are not in the record; they are confirmed against the DBH technical data sheet.

Typical applications for a seal of these dimensions include gearboxes, reducers, centrifugal pumps, electric motors, drive shafts and continuous process equipment. In all cases it serves to retain oil or grease inside the assembly and prevent the entry of external contaminants. It is a wear part that should be replaced when lubricant leakage, abnormal noise in the seal area or dirt accumulation around the lip appears.

For installation, verify that the shaft and housing are clean, free of burrs and marks, and that the lip contact surface has no deep grooves. Lubricate the lip with the same oil or grease used in the equipment before inserting it, and install the seal with a flat driver that presses on the outer diameter, never on the lip. Seal selection depends on the available shaft diameter, housing diameter and height; respect these three dimensions to ensure correct fit.

If you need an equivalent or a nearby size, send us code 8954 along with the shaft, housing and height dimensions you have on the equipment. You can also send a photo of the old seal or the assembly drawing. At MR Accesorios Industriales we compare this data against the DBH brand options and confirm compatible alternatives before quoting.

To proceed with the quote, write to us on WhatsApp and send code 8954 or the dimensions 62 x 90 x 10 mm. We will reply with the quote and the alternatives that fit your application.