DBH 8020 radial shaft seal — 47.62 x 73.06 x 12.7

DBH 8020 is a reference of radial shaft seal, within Seals. Request a quote for 8020 via WhatsApp or email with the quantity you need; we respond promptly with the quote and equivalents.

The DBH 8020 radial shaft seal is a lip seal that closes off the passage of oil or grease at the point where a shaft passes through a housing. It runs on a 47.62 mm shaft, fits into a 73.06 mm housing and is 12.70 mm high, with A 187 design. It is used in gearboxes, pumps, electric motors and power transmission equipment where lubricant must be retained and the ingress of dust or water stopped.

This item is a radial shaft seal from the DBH line, identified by part number 8020 and A 187 design. Its dimensions are 47.62 mm shaft, 73.06 mm housing and 12.70 mm height. The flexible lip bears on the rotating shaft and seals against the housing, so that the lubricant stays inside and contaminants stay outside. It is a common replacement part in equipment where the shaft is already machined and only the seal is replaced.

Typical applications are found in gearboxes, centrifugal pumps, motors, rollers and drive shafts. In all these cases the seal serves two functions: retaining the oil or grease of the bearing and preventing dust, chips or water from entering. It is also used as a secondary barrier in equipment with moderate vibration, provided the shaft speed and operating temperature match the original design of the assembly.

To install it, check that the shaft has no burrs or marks and that the seating surface is clean and lubricated. The seal is inserted perpendicular to the shaft, without striking the lip, and it is advisable to use a mounting tube or bushing of the appropriate diameter. Before choosing a replacement, compare the three dimensions and the lip design: a change in height or profile can prevent the seal from seating properly.

Send us the shaft, housing and height dimensions, plus a photo of the old seal if you have one. With that data we look for the equivalent in the same DBH line or in another brand we carry. MR Accesorios Industriales works with seals and oil seals for replacement, so we can also advise you if A 187 design is not the right one for your equipment.

To request a quote for the DBH 8020 oil seal, write to us on WhatsApp with the part number and quantity. If you have doubts about the size or design, send the shaft and housing dimensions and we will confirm them against the manufacturer's data sheet before giving you the quote.