Radial shaft seal DBH 6250 — 18.80 x 27.00 x 7.00

DBH 6250 is a radial shaft seal reference, within Seals. Request a quote for 6250 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DBH 6250 radial shaft seal is a lip seal that is mounted in the housing and seals against the rotating shaft to retain lubricant and block the entry of dust, water or particles. Its dimensions of 18.80 mm shaft, 27.00 mm housing and 7.00 mm height, with Ls design, make it suitable for compact equipment where axial space is limited. MR Accesorios Industriales carries it as part of its line of seals and oil seals for maintenance and repair.

This item is a DBH 6250 radial shaft seal, identified by its 6250 designation and by the dimensions listed in the data sheet: 18.80 mm shaft diameter, 27.00 mm housing bore diameter and 7.00 mm height. The Ls design corresponds to a seal with a single sealing lip and metal body, intended for rotating shafts with permanent lubrication. The 6250 nomenclature follows the DBH numbering system for compact-section seals and is used as a direct reference when ordering replacements.

Typical applications for a seal of this size include small gearboxes, electric motors, centrifugal pumps, reducers and transmission equipment where oil or grease leaks must be prevented and bearings protected from the environment. It also appears in machine tools, packaging equipment and light conveying systems. It is always advisable to verify that the shaft has no wear on the sealing track and that the housing is clean and free of burrs before installation.

To select the correct seal, compare the three dimensions with the housing and shaft: 18.80 mm shaft, 27.00 mm housing and 7.00 mm height. The Ls design indicates a sealing lip that runs on a lubricant film; therefore it is important that the shaft has adequate roughness and that the seal is installed with the lip face toward the fluid side to be retained. If the shaft shows a groove or wear, consider a repair sleeve or a nearby size.

If you need an equivalent or a close size, send us code 6250 or the dimensions 18.80 x 27.00 x 7.00 mm and the type of application. At MR Accesorios Industriales we can look for alternatives within the DBH line or from other brands we carry, always respecting the mounting dimensions. We can also advise you on the most suitable lip design according to the fluid, temperature and rotational speed of the equipment.

To request a quote for the DBH 6250 seal, send the code by WhatsApp to MR Accesorios Industriales. If you have doubts about the size or design, attach a photo of the old seal or the dimensions taken with a caliper. With that data we confirm the reference and send you the quote with no obligation.