Radial shaft seal DBH 5827 — 63.00 x 88.00 x 10.00

DBH 5827 is a radial shaft seal reference, within Seals. Request a quote for 5827 via WhatsApp or email with the quantity you need; we respond promptly with lead time and equivalents.

The DBH 5827 radial shaft seal is a lip seal designed for rotating shafts, with dimensions of 63 mm shaft diameter, 88 mm housing diameter and 10 mm height. Its function is to retain lubricant inside the assembly and prevent the entry of dust, water or particles that accelerate wear on bearings and bushings. It is a common replacement part in pumps, gearboxes, electric motors and power transmission equipment that run on shafts of that section.

This item is a radial shaft seal from the DBH line, identified with part number 5827. Its dimensions are 63.00 mm shaft diameter, 88.00 mm housing diameter and 10.00 mm height. The indicated design is Lz, a lip configuration suited to rotating shafts with lubrication. The elastomer and the internal spring are confirmed against the manufacturer's data sheet at the time of quoting.

Seals of this size are used in equipment where the shaft rotates inside a fixed housing and oil or grease must be contained. They appear in centrifugal pumps, gearboxes, electric motors, compressors and machine tools. They are also used as a secondary seal in bearing assemblies, where they protect the raceway and extend bearing service life. If the equipment operates with a lot of dirt or water, it is advisable to verify the lip type and the seal material.

To install a seal, check the condition of the shaft: no burrs, no deep marks and with the appropriate roughness. The housing must be clean and free of deformation. It is recommended to lubricate the lip before inserting it and to use an installation tool that presses on the outer edge, never on the lip. The 10 mm height defines the available axial space; if the housing is through-drilled, make sure the seal sits fully seated and centered.

If you need a nearby size or an equivalent, the most practical approach is to send part number 5827 or the dimensions 63 x 88 x 10 by WhatsApp. With that data we can look for an alternative from another brand or a design variant, always confirming technical characteristics. You can also ask about seals with nearby dimensions, such as 62 x 88 x 10 or 63 x 90 x 10, depending on the case.

At MR Accesorios Industriales we carry the DBH brand and have more than 80 years of experience in the industry. If you have doubts about the application or want to confirm that this seal is the right one for your equipment, send us the part number or a photo of the part by WhatsApp and we will advise you.